Vehicle jack and stand Proline 46803 — single-piece car lift support

Proline 46803 is a single-piece vehicle jack and stand designed to support a lifted car during maintenance and repair. This combined unit integrates the lifting and supporting functions into one stable tool suitable for workshop and home use. Supplied as one item, the device is intended to secure a vehicle after lifting to allow safe underbody access, wheel removal, brake work and other service tasks where a reliable support point is required.

Advantages

The single-piece design reduces setup complexity by combining the jack and stand into one compact unit that is easy to position beneath the vehicle. Constructed for stability, the support minimizes wobble and provides a consistent bearing surface for the chassis or axle. Its conventional form factor and straightforward mechanical components make the tool easy to use and maintain. As a dedicated support, it allows technicians and hobbyists to keep a lifted vehicle secure while performing inspections, repairs, or routine servicing.

Suitable for

• Routine underbody inspections and light maintenance
• Wheel and brake removal or replacement
• Small repairs where a raised, stable support is required
• Home garage use and light-duty workshop applications

Key specifications

• Type: combined jack and stand in a single unit
• Intended use: vehicle support after lifting for maintenance tasks
• Quantity: single unit supplied
• Compatibility: suitable for common passenger cars and light vehicles when used within rated capacity (verify vehicle weight and support position before use)
• Construction: rigid support structure designed to provide stable contact with chassis or axle

How to use

Place the unit on a level, solid surface and position it under the manufacturer-recommended support point of the vehicle. Use an appropriate lifting device to raise the vehicle to the required height, then slide or place the Proline 46803 support under that point and lower the vehicle slightly so load transfers onto the stand. Confirm the support is seated correctly and the vehicle is stable before working underneath. When the job is finished, lift the vehicle slightly again to remove the support, then lower the vehicle fully and store the unit in a dry place.

Usage recommendations

Always check the vehicle manufacturer’s recommended jacking and support points and ensure the support’s load capacity suits the vehicle. Use on a firm, level surface only and avoid working under a vehicle supported solely by this unit unless used as part of an appropriate jack/stand procedure. Regularly inspect the support for damage or excessive wear and replace it if structural integrity is compromised.