Corner clamp Proline 68 x 65 mm — woodworking alignment and holding tool

The Proline corner clamp 68 x 65 mm is a compact woodworking alignment and holding tool designed to secure two workpieces at a precise right angle. Sized for small frames, cabinets and trim work, it provides stable positioning during gluing, screwing or fastening operations. The clamp’s compact footprint and firm clamping surfaces help maintain square joints while you work, allowing accurate assembly without needing a second pair of hands.

Advantages

This corner clamp offers straightforward, repeatable alignment with a rigid frame that resists twisting under pressure. Its small dimensions make it convenient for confined workspaces and for handling thin stock or narrow mouldings. The clamp’s contact faces distribute pressure evenly to reduce surface marking and hold components securely during adhesive cure or fastener insertion. Designed for practical, everyday use, it speeds up assembly tasks that require consistent 90° joints.

Suitable for

• Assembling small picture frames and shadow boxes
• Joining cabinet carcasses, drawer fronts and casework
• Fixing trim, mouldings and corner joints during gluing
• Holding components in place for screw or nail insertion

Key specifications

• Clamping orientation: 90° corner alignment
• Effective clamping dimensions: approximately 68 x 65 mm
• Construction: rigid frame designed to resist twisting
• Contact surfaces: flat faces sized for small workpieces and trim
• Intended use: manual woodworking and assembly operations

How to use

Place the two workpieces into the clamp so their mating edges align against the internal faces at a right angle. Adjust the clamp until the faces contact both pieces evenly, then tighten the clamping mechanism until the parts are held firmly without excessive force that could damage the material. Verify squareness with a try square or measuring tool before applying glue or inserting fasteners. When gluing, leave the clamp in place until the adhesive reaches handling strength.

Usage recommendations

Use protective pads between the clamp faces and finished surfaces to prevent marring on softwoods or veneers. Check alignment periodically during adhesive cure and avoid overtightening on delicate edges. For repetitive production tasks, inspect the clamp for wear and keep contact faces clean to ensure consistent clamping pressure.