Power Cable QOLTEC with Angled SCHUKO CEE 7/7 (E/F) to IEC C13, 3×1.0 mm², 2 m

Power Cable QOLTEC with Angled SCHUKO CEE 7/7 (E/F) to IEC C13, 3×1.0 mm², 2 m is a mains lead designed to deliver AC power from a wall outlet with a SCHUKO (CEE 7/7) socket to devices that accept an IEC C13 connector. The cable is 2 metres long and contains three conductors of 1.0 mm² cross-section, providing a balance of flexibility and current carrying capacity for typical office and home IT equipment. The angled SCHUKO plug reduces protrusion and helps with routing the cable in tight spaces behind furniture or equipment racks.

Advantages

The angled SCHUKO (CEE 7/7) plug offers reduced strain on the plug and socket and improves cable management in confined areas. The IEC C13 connector is a standard interface for many PCs, monitors, printers and UPS devices, ensuring broad compatibility. The 3×1.0 mm² conductor construction delivers stable power transmission for devices with moderate current draw while maintaining pliability for easy installation.

Suitable for

• Desktop computers and workstations equipped with an IEC C13 inlet
• Monitors, printers and multifunction office devices
• Uninterruptible power supplies (UPS) and power distribution units (PDUs) with IEC C13 sockets
• Home entertainment equipment and small servers with IEC C13 connectors

When it may not be suitable

This cable is intended for devices that use an IEC C13 inlet and for mains systems compatible with the SCHUKO (CEE 7/7) plug. It is not suitable for equipment that requires higher gauge conductors, specialized plugs, or hardwired connections. It should not be used where local regulations demand a different connector type or where the current rating of connected equipment exceeds the cable’s safe capacity.

Key specifications

• Cable length: 2 m
• Plug type (mains): Angled SCHUKO (CEE 7/7, E/F)
• Device connector: IEC C13
• Conductors: 3 cores
• Conductor cross-section: 1.0 mm² per core
• Application: Mains power for IT and office equipment

How to use

Insert the angled SCHUKO plug into a compatible mains socket, ensuring the plug is fully seated and that the socket and plug are free of damage. Connect the IEC C13 end to the device’s inlet until it clicks or seats firmly. Route the cable to avoid sharp bends, pinch points and heat sources. For equipment with high power draw or critical operation, verify that the combined current of connected devices does not exceed the cable’s rating and the destination socket’s capacity.

What to consider before purchase

• Confirm your device uses an IEC C13 inlet and your wall outlet accepts a SCHUKO (CEE 7/7) plug
• Check the required current draw of your equipment to ensure compatibility with a 1.0 mm² conductor cable
• Measure the required cable length and routing path to ensure 2 m is sufficient
• Verify local regulations or installation standards for plug types and cable ratings

Usage recommendations

For reliable operation, use the cable for typical office and home IT equipment, avoid subjecting it to excessive mechanical stress, and replace the cable if the insulation or connectors show any signs of wear or damage.