Low-Expansion Assembly Foam Quantec PMPPLE-750 750 ml Can for Installation Work

Quantec Low-Expansion Assembly Foam PMPPLE-750 in a 750 ml can is formulated for controlled, low-expansion application during installation and sealing work. The product is suitable for precise filling and bonding where minimal outward pressure is required, such as around door and window frames, utility penetrations and joints that demand accurate foam placement. The foam adheres to common building substrates and cures to a stable cellular structure compatible with cutting and trimming after full curing.

Advantages

This low-expansion assembly foam provides consistent, predictable yield and reduced risk of material blow-out during application. It enables accurate dosing and neat finishing because of its low expansion characteristics. Once cured, the foam offers thermal and acoustic insulation properties and good adhesion to masonry, wood, metal and many plastics. The 750 ml can size supports extended application runs while remaining compatible with standard foam dispensing guns.

Suitable for

• Sealing gaps and joints around doors and windows
• Insulating and fixing window and door frames
• Filling penetration points for pipes and cables
• Applications where low expansion is required to avoid deformation or excessive pressure

Key specifications

• Formulation: low-expansion polyurethane assembly foam
• Container volume: 750 ml
• Application compatibility: suitable for use with standard foam guns
• Curing: cuttable and trimmable after full cure
• Performance: reduced expansion to limit outward pressure during curing

How to use

Shake the can according to manufacturer guidance before use and attach to a compatible foam gun. Apply to clean, dry and dust-free surfaces; pre-wetting porous substrates can improve adhesion and yield. Dispense foam into joints and cavities, allowing room for the product to expand slightly. After partial curing, trim the surplus foam and finish the surface as required. Follow local ventilation and safety recommendations while applying and curing.

Usage recommendations

Use personal protective equipment such as gloves and eye protection. Store the can upright at moderate temperatures and avoid exposure to frost. Test adhesion on inconspicuous areas if compatibility with specific plastics or treated surfaces is uncertain. Allow full cure time before mechanical loads or final finishing.