Coaxial UHF Cable Rangeful HF240-PL-PL-1 50 Ω, 1 m, PL-259 to PL-259

UHF coaxial cable Rangeful HF240-PL-PL-1 is a 1 m, 50 Ω jumper equipped with PL-259 (UHF) male connectors on both ends. Intended for radio, amateur (ham) radio, CB and VHF/UHF equipment connections, this coaxial lead offers a standard 50-ohm impedance for RF signal transfer and straightforward mating between transceivers, antennas and adapters. The cable is supplied ready for immediate use and provides a flexible connection option where short, reliable RF links are required.

Advantages

The Rangeful HF240-PL-PL-1 combines standard 50 Ω impedance and commonly used PL-259 connectors to ensure compatibility with a wide range of RF equipment. Its 1 m length offers a compact, low-loss connection for close-proximity setups while remaining flexible for easy routing. The pre-terminated connectors eliminate the need for soldering or crimping, allowing quick installation and swapping of equipment in field or bench environments.

Suitable for

• Connecting transceivers to mobile or base antennas in amateur radio setups
• Linking CB radios to antenna mounts or adapters
• Temporary or bench use for VHF/UHF equipment testing and troubleshooting
• Interfacing between adapters, patch panels and RF accessories

Key specifications

• Impedance: 50 Ω
• Length: 1 m
• Connector type: PL-259 (UHF) male — both ends
• Cable use: UHF coaxial jumper for RF signal transfer
• Flexibility: suitable for close-proximity routing and temporary connections

How to use

Ensure both mating connectors on your equipment are clean and free of debris before connecting. Align each PL-259 male connector with the corresponding SO-239 or compatible female socket and hand-tighten the connector body until a secure mechanical and electrical contact is achieved; avoid over-tightening. For permanent installations, verify connector seating and strain relief; for temporary or bench use, connect and disconnect as needed during testing or configuration changes.

Usage recommendations

Use the Rangeful HF240-PL-PL-1 for short runs where mechanical stress is limited and signal reflections are minimized by matching 50 Ω systems. Avoid sharp bends and repeated flexing at the connector ends to maintain connector integrity and consistent RF performance. Store the cable coiled without tight loops when not in use and inspect connectors periodically for corrosion or wear.