Coaxial cable Rangeful HF400 BNC male to PL259 UHF 15 m, full copper, 50 Ω

The Rangeful HF400 BNC male to PL259 UHF 15 m coaxial cable is a 15‑metre RF lead engineered for 50 Ω systems. It pairs a BNC male connector on one end with a PL259 UHF connector on the other and is built with full copper conductors. The cable is intended for HF, VHF and UHF radio use, amateur radio setups, scanners and general RF signal transmission where a flexible, low‑loss link between equipment is required.

Advantages

This coaxial cable combines full copper conductors with a 50 Ω impedance to provide consistent signal transfer and controlled attenuation over the 15 m length. The BNC male and PL259 UHF connectors allow connection between a variety of transceivers, scanners and antennas without adapter chains. The construction supports both portable and fixed installations and aims to reduce insertion loss compared with lower‑quality cable assemblies.

Suitable for

• HF, VHF and UHF amateur radio stations
• Handheld and base scanners requiring a 50 Ω feed
• Connecting transceivers to external antennas or tuners
• Portable field setups and fixed station cabling

Key specifications

• Cable length: 15 m
• Connectors: BNC male to PL259 (UHF)
• Conductor material: full copper
• Impedance: 50 Ω
• Intended frequency ranges: HF, VHF, UHF signal transmission

How to use

Route the 15 m coaxial cable between your transceiver, scanner or other RF device and the antenna or accessory, ensuring both ends are clean and free of debris before connection. Align the BNC male with the BNC jack and push-and-twist until secure; screw the PL259 connector onto the mating SO-239/UHF socket until finger-tight and verify a firm mechanical and electrical connection. Avoid tight bends near the connectors and support the cable along its run to prevent strain on connector joints.

Usage recommendations

For best performance, keep cable runs as short as practical, avoid kinking the cable and secure it away from sources of strong electromagnetic interference. Inspect connectors periodically for corrosion or wear and replace the cable if outer jacket damage exposes the inner conductor or dielectric.