Coaxial cable Rangeful HF400-NF-SM-10 10 m SMA male to N female UltraFlex

Rangeful HF400-NF-SM-10 is a 10 m flexible coaxial cable with an SMA male connector on one end and an N female connector on the other. The UltraFlex construction combines a flexible dielectric and a braided shield to provide reliable RF signal transmission while allowing easy routing around equipment and through confined spaces. It is designed for laboratory use, test setups and antenna connections where a durable, low-loss interconnect is required.

Advantages

The UltraFlex design reduces stiffness and enables tighter bending radii compared with standard coaxial assemblies, simplifying installation in crowded racks and enclosures. High-quality SMA male and N female terminations ensure stable mechanical engagement and repeatable electrical performance. The cable construction prioritizes consistent characteristic impedance and reduced microphonic effects to maintain signal integrity over the full run.

Suitable for

• RF test benches and measurement setups
• Antenna feed lines for indoor and sheltered outdoor equipment
• Connecting transceivers, amplifiers and spectrum analyzers
• Laboratory and prototyping environments requiring flexible routing

Key specifications

• Length: 10 m
• Connectors: SMA male to N female
• Cable type: UltraFlex coaxial construction
• Impedance: 50 ohm nominal
• Flexible dielectric and braided shield for enhanced bendability
• Operating applications: RF signal transmission, test and measurement

How to use

Inspect connectors for damage or contamination before use and ensure mating interfaces are clean and properly aligned. Thread the SMA male connector onto the mating SMA female jack until hand-tight, then secure the N female connector to the corresponding N male connector using appropriate torque or hand-tightening depending on the application. Avoid sharp bends and do not exceed the cable's minimum bend radius; route the cable to prevent kinking and to minimize stress on connector junctions. For temporary test setups, support the cable so that its weight does not place undue strain on instrument connectors.

Usage recommendations

The cable is intended for indoor and sheltered use; avoid prolonged exposure to direct sunlight, excessive moisture or corrosive environments. For critical RF measurements, verify connections with a network or spectrum analyzer and replace the cable if mechanical wear or electrical degradation is observed.