Coaxial cable Rangeful FME Male–FME Male RG58/U 50 Ω, 3 m

Rangeful 3-meter coaxial cable with FME male connectors on both ends uses RG58/U construction and a nominal 50 Ω impedance. The cable provides a flexible RF connection for antennas, routers, modems and measurement equipment where compact FME terminations are required. Its 3 m length allows routing between devices and external antennas while maintaining a standard 50-ohm transmission line for predictable signal behaviour.

Advantages

The RG58/U dielectric and braided shield deliver a balance of flexibility and shielding appropriate for short-run RF connections. FME male connectors on both ends offer a compact footprint suitable for installations with limited space or where low-profile terminations are preferred. The 50 Ω impedance matches common RF equipment, reducing reflections and preserving signal continuity in typical wireless and test setups.

Подходит для

• Подключение автомобильных и портативных антенн
• Соединение маршрутизаторов и модемов с внешними антеннами
• Краткосрочные монтажи в лабораторной и испытательной среде
• Инсталляции с ограниченным пространством вокруг разъёмов

Key specifications

• Cable type: RG58/U coaxial
• Impedance: 50 Ω nominal
• Connector type: FME male — both ends
• Length: 3 m
• Construction: solid centre conductor with braided shield and dielectric suitable for RF applications

How to use

Connect each FME male connector to the corresponding FME female port on the antenna, modem, router or test instrument. Ensure connectors are fully seated and hand-tightened to avoid intermittent contact; do not overtighten with tools to prevent damage to the compact FME bodies. Route the cable to avoid sharp bends and excessive compression; maintain a bend radius several times the cable diameter to preserve characteristic impedance and minimise insertion loss.

Usage recommendations

For best performance keep the cable run as short as practical and use appropriate strain relief where the cable exits equipment or passes through panels. Inspect connectors periodically for corrosion or mechanical wear, especially in mobile or outdoor installations, and replace the cable if shielding or connector integrity is compromised.