Self-Adhesive Markers Revopoint (208 pcs) – coded sticky targets for 3D scanning and photogrammetry

Revopoint Self-Adhesive Markers (208 pcs) are coded sticky targets intended to improve registration, tracking and alignment in 3D scanning and photogrammetry workflows. The set contains 208 uniquely coded adhesive markers that act as precise reference points for scanners and cameras, helping to accelerate setup and increase the reliability of multi-view alignment. Markers are suitable for use with Revopoint scanners (including the MIRACO Plus) and other compatible 3D scanning systems across industrial inspection, prototyping, heritage digitization and medical modelling tasks.

Advantages

The coded design enables the scanner software to identify each marker individually, which reduces tracking loss and supports smoother reconstruction of complex surfaces. The sticky backing allows quick placement on a wide range of materials, shortening preparation time. Compact marker size permits placement on small details as well as larger objects without significantly altering scan geometry or occluding features.

Suitable for

• 3D scanning and photogrammetry setups requiring reliable registration points
• Multi-view capture of objects with feature-poor or reflective surfaces
• Reverse engineering and prototyping where repeatable alignment is needed
• Museum and heritage digitization projects for accurate object mapping
• Industrial inspection and quality control workflows that use structured or handheld scanners

When it may not be suitable

This marker set may not be appropriate for applications that require non-permanent, residue-free marking on delicate surfaces, since the adhesive backing could leave traces or not adhere well to highly porous or dusty materials. It is also unnecessary when scanning objects that already provide abundant distinctive geometry and texture for reliable feature-based registration.

Key specifications

• Quantity: 208 coded self-adhesive markers
• Marker format: coded target with unique pattern for automatic identification
• Marker size: 22 × 22 mm
• Dot diameter (code elements): 5 mm
• Mounting: pressure-sensitive adhesive backing for direct application to surfaces

How to use

Clean the surface area where each marker will be applied to ensure good adhesion and avoid dust or oils. Peel a marker from the backing and press it firmly onto the object at the planned locations, distributing markers to cover different angles and depths for better multi-view registration. Scan the object with your Revopoint or compatible scanner following normal capture procedures; the scanning software will recognise the printed codes and use them to align frames and optimize registration. After scanning, remove markers carefully; if adhesive residue appears, use a suitable solvent recommended for the scanned material.

What to consider before purchase

• Surface compatibility: check that the adhesive is suitable for the materials you will scan (avoid extremely porous or powdery surfaces)
• Residue sensitivity: for delicate or finished surfaces, verify whether the adhesive may leave residue or cause damage
• Marker size and quantity: 208 markers of 22 × 22 mm—confirm this amount and size fit your typical scanning setups
• Software compatibility: ensure your scanning or photogrammetry software recognises coded targets or can be configured to use them

Usage recommendations

Place markers to create overlap across views and avoid clustering them too close together. For best results, combine coded markers with natural features of the object and perform a short test scan to verify detection before capturing the full model.