Floor paint RILAK AUREKS 60 C Base — water-based floor coating, 0.85 L

RILAK AUREKS 60 C Base is a 0.85 L water-based floor coating concentrate intended for interior floor surfaces. Supplied as a tintable base, the product is formulated to deliver a protective and decorative finish after tinting and proper application. It is suitable for use on prepared wooden floors, concrete substrates and previously painted floors where a water-based finish is required for renovation or maintenance in homes and light commercial spaces.

Advantages

The water-based composition reduces solvent odor and allows faster drying compared with traditional solvent-based floor coatings. As a tintable base, it provides flexibility in obtaining custom shades with compatible colorants and systems. The coating forms a protective film that resists normal foot traffic and helps to seal and even out surface appearance on prepared substrates. Low-VOC formulation supports indoor use when applied with adequate ventilation.

Suitable for

• Interior wooden floors and floorboards after sanding and priming
• Concrete and cement screeds in living areas and light-traffic commercial zones
• Previously painted floors where the existing coating is sound and properly prepared
• Small renovation and maintenance projects in residential apartments, offices and retail spaces

When it may not be suitable

As a base (concentrate) for tinting, the product requires correct colorant addition and thorough mixing; it is not ready-to-use straight from the can for final color. It is not intended for exterior use or for industrial floors exposed to heavy mechanical loads, continuous moisture, oil spills or aggressive chemicals.

Key specifications

• Type: water-based floor coating (tintable base)
• Volume: 0.85 L
• Intended use: interior floors — wood, concrete, previously painted surfaces
• Finish: protective decorative coating after tinting and curing
• Application methods: brush, roller or suitable spray equipment (after tinting and thinning if required)
• Drying: short drying time typical for water-based systems (final cure depends on film thickness and ambient conditions)

How to use

Prepare the surface by removing dust, grease and loose material; sand glossy or uneven areas and fill cracks or holes with appropriate filler. Ensure the substrate is dry and sound before application. Tint the base with compatible colorants following the tinting system guidelines and mix thoroughly to a uniform color. Apply one or more coats using a brush, roller or spray, allowing recommended drying time between coats. Lightly sand between coats if a smoother finish is required. Observe ventilation and temperature recommendations during application and curing.

What to consider before purchase

• Requires tinting with compatible colorants to achieve final color — plan for color mixing service or suitable tinting equipment
• Not suitable for exterior floors or heavy-duty industrial environments
• Check substrate condition: previously painted surfaces must be sound and properly prepared
• Estimate quantity based on floor area, number of coats and surface porosity

Usage recommendations

Use on well-prepared, dry substrates; apply at recommended film thickness and allow adequate drying time between coats. For best results, test the tint and finish on a small area before full application and ensure adequate ventilation during drying.