Standoffs Rittal SZ 2422.000 M12 height 10 mm, silver, pack of 4

Rittal SZ 2422.000 standoffs are M12 distance spacers with a 10 mm height and a silver finish, supplied as a pack of four. They are designed for use with TS roof panels and similar enclosure components to create a defined separation between panels, fittings or accessories. These standoffs help achieve secure fastening and consistent spacing when assembling electrical cabinets or modifying enclosure roof height for ventilation.

Advantages

The standoffs provide a reliable and uniform 10 mm separation that simplifies mounting and alignment of roof panels. Their M12 thread ensures compatibility with common fasteners used in enclosure assembly, and the silver finish offers corrosion resistance appropriate for indoor and controlled-environment installations. Supplied in a set of four, they allow quick replacement or modification of panel mounting points while maintaining mechanical stability.

Suitable for

• Raising TS 8 roof panels to improve ventilation
• Creating consistent spacing between enclosure panels and accessories
• Mounting roof vents, filters or small accessories on electrical cabinets
• General enclosure assembly where M12 spacers of 10 mm height are required

When it may not be suitable

These standoffs are intended for mechanical separation and standard enclosure mounting; they are not load-bearing components for supporting heavy equipment or structural loads. They are also not suitable for use in applications requiring transportation by crane or where certified lifting points are needed.

Key specifications

• Thread size: M12
• Height: 10 mm
• Finish: silver
• Package quantity: 4 pieces
• Typical application: roof panel spacing for TS enclosures

How to use

Install the standoffs by aligning them with the threaded mounting points on the TS roof panel and hand-start the M12 fasteners to ensure proper engagement. Tighten to the appropriate torque specified for the cabinet hardware to secure the spacer without deforming the panel. Use matching nuts or bolts as required by the enclosure design. When raising a roof for ventilation, ensure all four standoffs are fitted evenly to maintain a level gap and verify that added airflow does not compromise IP protection or equipment cooling requirements.

What to consider before purchase

• Confirm M12 thread compatibility with your enclosure fasteners
• Verify that a 10 mm spacer height meets ventilation and clearance needs
• Check environmental conditions to ensure silver finish is suitable
• Ensure these spacers meet your mechanical and safety requirements (not for crane lifting)

Usage recommendations

For consistent results, fit all four standoffs when modifying a TS 8 roof and use matched hardware tightened to recommended torque values. Inspect mounting points after installation and periodically during maintenance to ensure secure fastening and preserved enclosure protection.