End cover Rittal SV 9342.074, grey, pack of 2

Rittal SV 9342.074 end cover is a grey, two-piece set designed to provide a neat finished edge and protection for exposed ends of compatible Rittal enclosures and profiles. Supplied as a pack of 2, the covers fit over cut or open profile ends to prevent ingress of dust and to reduce the risk of contact with sharp edges, helping maintain a safer and tidier appearance for electrical panels, industrial cabinets and machine frames.

Advantages

The end cover offers a simple mechanical solution to close off open profile ends without modifying the original structure. Its neutral grey colour integrates with typical industrial cabinets and frames while resisting visible soiling. Supplied in pairs, the covers are ready to install and help extend the functional finish of enclosure profiles by protecting internal components from mechanical damage and accidental contact.

Suitable for

• Finishing cut ends of aluminium or steel enclosure profiles
• Electrical distribution panels and control cabinets
• Industrial machine frames and mounting rails
• Applications where a clean, protected edge is required to prevent injury or ingress of debris

When it may not be suitable

The end cover is intended for compatible Rittal profiles and may not fit non-standard or heavily modified profile shapes. It does not provide sealing against high-pressure water or complete dust-tight protection; for IP-rated closure or environmental sealing, dedicated gaskets or sealed covers should be used. Also, it is not a structural component and should not be used to support loads.

Key specifications

• Colour: grey
• Quantity: pack of 2 pieces
• Function: end cover for profile termination and edge protection
• Typical use: interior finishing of enclosures, panels and frames

How to use

Measure the profile end to confirm compatibility with the Rittal end cover before installation. Align the cover with the profile end and press it into place until it seats securely; some covers may require slight tapping with a soft mallet to achieve full engagement. Ensure the profile edge is free of burrs and debris prior to fitting to avoid damage to the cover and to ensure a proper fit. For long runs, fit covers at both ends and inspect periodically for secure seating.

What to consider before purchase

• Confirm compatibility with the profile type and cross-section used in your enclosure or frame
• Verify that grey colour and finish match the intended installation visually
• Determine whether a sealed or load-bearing solution is required instead of a simple end cover

Usage recommendations

For reliable results, install the covers on clean, deburred profile ends and consider using suitable cable management and sealing accessories where environmental protection or additional mechanical protection is needed.