Paint Sadolin PAINT EASYCARE BW 10L — water-based interior/exterior paint, 10 L

Sadolin PAINT EASYCARE BW 10L is a water-based interior and exterior paint formulated for general-purpose wall and ceiling coating. Suitable for plaster, concrete, masonry and properly primed substrates, this 10-litre finish is intended to protect and refresh surfaces in homes and commercial spaces while allowing straightforward application and routine maintenance.

Advantages

This water-based formulation offers good hiding power and a washable surface that simplifies cleaning and upkeep. EASYCARE provides a uniform matt to low-sheen appearance with reduced odour compared to solvent-based paints and dries to touch within a practical timeframe for typical renovation schedules. The product is designed to adhere to common mineral and previously painted surfaces when appropriate primers or preparation are used.

Suitable for

• Interior walls and ceilings in living spaces, corridors and public areas
• Exterior vertical surfaces such as rendered façades and masonry (when local conditions and preparation are suitable)
• Plaster, concrete and cement-based substrates
• Previously painted surfaces after cleaning and priming as required

Key specifications

• Base: water-based acrylic dispersion
• Finish: matt to low sheen
• Volume: 10 litres
• Coverage: typical coverage rate depends on substrate porosity and application method; check wet-film thickness for accurate planning
• Drying: touch-dry under normal conditions within a few hours; recoat time varies with temperature and humidity
• Suitable substrates: plaster, concrete, masonry and primed surfaces

How to use

Ensure surfaces are clean, dry and free from loose material, grease and mould. Repair cracks and uneven areas, then sand and remove dust. Prime highly absorbent, chalking or repaired areas with a suitable primer before applying the paint. Stir the paint thoroughly before use. Apply using brush, roller or airless spray according to substrate and desired appearance; follow manufacturer guidance on thinning and spray setup if required. Allow sufficient drying time between coats and avoid application in temperatures outside the product’s recommended range.

Usage recommendations

For best results, test the paint on a small area to confirm adhesion and final appearance on the chosen substrate. Use appropriate primers on new or porous surfaces and observe local climate conditions during exterior application to prevent adverse effects from rain or low temperatures.