Pump control module SALUS PL06 230V for heating systems, single pump control

SALUS PL06 is a 230V pump control module designed for heating systems to manage a single circulation pump. The module receives switching commands from room controllers, thermostats or other control units and provides safe electrical switching of the pump motor. Its compact design and standard voltage compatibility make it suitable for integration into residential and light commercial heating installations where automated pump control and basic pump protection are required.

Advantages

The SALUS PL06 enables reliable on/off control of a circulation pump with 230V supply, reducing manual intervention and improving system responsiveness to thermostat signals. It supports straightforward wiring and installation in typical heating cabinets or near pump assemblies. The unit provides basic electrical isolation and switching capability to protect controllers from direct motor load, contributing to longer controller life and stable pump operation.

Suitable for

• Single-circulator heating circuits in residential buildings
• Hydronic underfloor heating manifolds with one pump
• Boiler or heat source systems requiring external pump switching
• Light commercial heating applications with a single pump

Key specifications

• Supply voltage: 230 V AC
• Control input: compatible with standard thermostat/controller switching outputs
• Output: single pump switching relay suitable for circulation pumps
• Mounting: compact unit for installation near pump or inside control cabinet
• Intended environment: indoor use in dry locations within heating systems

How to use

Install the SALUS PL06 according to local electrical regulations, connecting the 230V supply, the pump motor wiring, and the control signal from the thermostat or controller. Ensure power is turned off before wiring. Mount the module in a protected, ventilated location close enough to the pump to keep cable runs short. After wiring, restore supply and test operation by issuing on/off commands from the connected controller; confirm that the pump starts and stops as expected and that connections remain secure.

Usage recommendations

Use the SALUS PL06 with compatible controllers and thermostats that provide a dry contact or low-voltage switching output suitable for the module. Verify pump load and cable ratings to ensure they match the module's switching capacity and follow national wiring standards. For installations in humid or exposed environments, locate the module inside a suitable enclosure to protect against moisture and mechanical damage.