SANHA PRESS SOLAR elbow 45° 28 mm by SANHA — press-fit solar piping component

SANHA PRESS SOLAR elbow 45° 28 mm is a press-fit solar piping component designed for redirecting fluid flow in solar thermal and heating circuits. Manufactured from materials compatible with press-connection systems, the fitting creates a permanent, leak-resistant joint when installed with the appropriate press tool and compatible ring inserts. The compact 45° angle allows directional changes in confined spaces while maintaining hydraulic efficiency in closed-loop systems.

Advantages

The SANHA PRESS SOLAR 45° elbow offers a secure press connection that eliminates the need for soldering or threaded joints, reducing installation time and heat-related risks. Its geometry supports smooth flow transitions with minimal pressure loss at the bend. The fitting is manufactured to meet demands of solar and heating applications, delivering corrosion-resistant performance and a consistent sealing surface for reliable long-term operation.

Suitable for

• Solar thermal collector arrays and distribution circuits
• Closed heating circuits in residential and commercial systems
• Pipe routing in compact or constrained installation spaces
• Systems that use compatible press-fit joining methods and inserts

When it may not be suitable

This 45° press elbow is intended for closed solar and heating loops using compatible press systems; it is not suitable for direct potable water systems unless the material and approval data for potable use are verified for the specific system. It is also not appropriate where threaded or welded joints are explicitly required by design, local codes, or where high-temperature brazing is specified.

Key specifications

• Connection type: press-fit elbow
• Angle: 45°
• Nominal diameter: 28 mm
• Intended application: solar thermal and heating circuits
• Material characteristics: corrosion-resistant metal suitable for closed-loop systems

How to use

Prepare the pipe ends by cutting square and deburring to ensure proper fit. Slide the compatible press-ring or insert onto the pipe as required by the press system instructions, assemble the elbow onto the pipe ends fully, and operate the approved press tool with the correct jaw or ring profile until the press cycle completes. Verify each joint visually and, where applicable, perform a pressure test of the circuit following local installation standards and manufacturer guidance.

What to consider before purchase

• Confirm compatibility with the press-fit system and press jaws in use.
• Verify that 28 mm nominal diameter matches the piping and system requirements.
• Ensure material suitability for the intended fluid, temperature range, and system pressures.
• Check local regulations for use in potable water systems if that application is intended.

Usage recommendations

Use the SANHA PRESS SOLAR 45° elbow with manufacturer-recommended press tools and inserts, follow accepted cutting and deburring practices, and perform pressure testing after installation to confirm joint integrity. Maintain accessible service space around bends for inspection and possible future maintenance.