SANHA press elbow connector 45° 22 mm, model 1604122

The SANHA press elbow connector 45° 22 mm is a press-fit plumbing fitting designed to create a compact 45-degree change of direction in metal or compatible press piping systems. Intended for professional plumbing applications, this connector provides a secure joint when installed with a compatible press tool and press rings. The connector's 22 mm nominal diameter is suitable for common domestic and commercial water and heating lines where a small-angle deviation is required.

Advantages

This 45° press elbow offers a reliable, permanent joint when pressed with the correct tooling. Its compact angled profile saves space in tight installation areas and simplifies routing compared with multiple straight fittings and bends. The press connection reduces the need for soldering or threading, which speeds up installation and minimises on-site preparation. The fitting is designed for durability in standard plumbing environments and for compatibility with common press-system components.

Suitable for

• Changing pipe direction by 45° in water supply lines
• Routing domestic and commercial heating circuits
• Tight spaces where a compact angled joint is required
• Professional plumbing installations and service repairs

Key specifications

• Angle: 45° elbow
• Nominal diameter: 22 mm
• Connection type: press-fit
• Material compatibility: suitable for metal press piping systems
• Application: water and heating lines

How to use

Ensure pipe ends are cut square, deburred and cleaned before assembly. Slide the appropriate press sleeve or ring over the pipe, insert the pipe fully into the connector until it seats, and position the press jaw over the sleeve. Activate the compatible press tool following the tool manufacturer's instructions to complete the joint. Verify the pressed connection visually and, where required, perform a pressure test in accordance with applicable regulations or project specifications.

Usage recommendations

Use only press tools and accessories approved for the specific press system and sleeve type. Follow installation standards and local codes for potable water and heating systems; avoid using damaged or deformed fittings and replace damaged components before pressing.