Bench vice accessory Scangrip 06.0125 (MPN 8250734125)

Scangrip MAGNEFIX N bench vice accessory is a hardened aluminium neutral jaw designed to fit workshop vises and provide secure clamping for rough to medium-finish and machined workpieces. Supplied as a replacement or upgrade jaw, this accessory is intended to protect both the vise and the clamped components while improving grip and stability during repair, assembly, and maintenance tasks on small parts made of metal, plastic or mixed materials.

Advantages

The hardened aluminium construction offers a balance of durability and surface protection, reducing the risk of marking or deforming delicate workpieces. Its neutral profile makes it suitable for general clamping where a flat, non-specialised jaw face is required. The accessory is lightweight yet robust, enabling easy installation and minimal additional load on the vise while providing consistent holding force for repetitive workshop tasks.

Suitable for

• Clamping small metal parts during repair and machining
• Holding plastic components for assembly or finishing
• Supporting mixed-material items where a neutral jaw face is required
• Replacing worn or damaged vice jaws to restore clamping accuracy

Key specifications

• Material: hardened aluminium
• Jaw type: neutral flat-faced jaw for rough to medium finish workpieces
• Available jaw width (examples): 125 mm; other sizes in the same series range from 100 mm to 180 mm
• Typical weight for 125 mm size: approximately 220 g
• Designed for use with bench/workshop vises and standard vice mounting systems

How to use

Install the MAGNEFIX N jaw by removing the existing jaw insert from the vise and fitting the accessory in the original mounting position, ensuring secure fastening according to the vise manufacturer's instructions. Position the workpiece between the jaws and tighten the vise until the workpiece is held firmly without excessive compressive force. Check alignment and adjust as needed to maintain parallel clamping surfaces and avoid slippage during operations such as filing, drilling or light machining.

Usage recommendations

Use the neutral aluminium jaw when a flat, non-marking contact surface is preferred; avoid using it for extremely soft or highly finished surfaces where alternative softer or coated jaws may better protect the workpiece. Regularly inspect the jaw face for wear and replace when surface damage could compromise clamping stability. Follow general vise safety: secure the vise to the bench, wear appropriate personal protective equipment, and avoid over-tightening.