SCOT BT-2DSN2 surface-mounted exit button SCOT BT-2DSN2

The SCOT BT-2DSN2 surface-mounted exit button is a wall-mounted control switch designed for access control and door release systems. It enables manual triggering of electric locks or access panels and is intended for installation on surface conduits. The unit is compact and suited to environments where a visible, easily reachable exit push-button is required, such as offices, commercial premises and controlled entry/exit points.

Advantages

The exit button provides a simple mechanical interface for door release systems, offering straightforward operation and durable wall-mounted construction. Its surface-mounted design simplifies installation on existing conduits without the need for flush mounting. The device is compatible with a variety of electric locking mechanisms and typical access control wiring schemes, allowing integration into standard systems used in commercial and office environments.

Suitable for

• Office interior doors requiring a dedicated exit push-button
• Commercial premises and retail outlets with controlled exits
• Entry/exit points in buildings with surface conduit installations
• Access control systems that require a simple manual release input

When it may not be suitable

This surface-mounted exit button is not intended for outdoor use unless installed in a suitably rated enclosure; exposure to weather or moisture may affect its operation. It may also be unsuitable where a vandal-resistant or highly tamper-proof solution is required, or where flush-mounted, concealed controls are preferred for aesthetic or security reasons.

Key specifications

• Mounting type: surface-mounted for wall installation
• Function: manual exit push-button for door release/access control
• Compatibility: designed to interface with common electric locks and access panels
• Construction: durable plastic or metal housing suitable for interior use
• Operation: momentary push action for triggering door release

How to use

Install the SCOT BT-2DSN2 on a suitable surface conduit or wall panel following local wiring regulations and the access control system's wiring diagram. Connect the device to the control panel or lock release input so the momentary push completes the release circuit. After wiring, secure the unit to the wall, verify mechanical operation of the button, and test electrical operation by triggering the connected lock or access controller to confirm correct response.

What to consider before purchase

• Confirm that a surface-mounted push-button meets your building's aesthetic and security requirements
• Verify compatibility with your access control system and the required input type (momentary contact)
• Check whether indoor-only construction is acceptable or if a weatherproof enclosure is needed for exposed locations

Usage recommendations

For reliable operation, mount the button at an appropriate height for users, route wiring in compliance with local electrical codes, and test the button regularly as part of routine access control maintenance. Use a protective cover or tamper-resistant fastening where additional vandal resistance is needed.