Speaker cable ShiverPeaks 06-180711-V, 1.5 mm² conductor, 10 m length

Speaker cable ShiverPeaks 06-180711-V, 1.5 mm² conductor, 10 m length is a 10‑metre audio connection cable with a 1.5 mm² conductor cross‑section intended for connecting loudspeakers to amplifiers or receivers in domestic audio setups. The cable is suitable for standard low‑voltage speaker lines and supports short to medium length runs where a 1.5 mm² gauge meets the power and impedance requirements. The transparent jacket and CCA (copper‑coated aluminium) conductor construction provide a balance between cost and conductivity for typical home stereo and multichannel installations.

Advantages

The cable offers a consistent conductor size of 1.5 mm² across its 10 m length, which simplifies planning and installation for room‑scale audio systems. Its CCA conductor construction reduces material cost while maintaining the flexibility needed for in‑wall or surface routing. The transparent outer jacket makes it easier to identify polarity markings and routing paths, and the cable’s uncomplicated single‑pair design is compatible with common speaker terminals and binding posts.

Suitable for

• Connecting bookshelf, floorstanding or satellite loudspeakers to home amplifiers and receivers
• Short to medium speaker runs in living rooms, home theaters and multiroom setups
• In‑wall or surface mounting where a 1.5 mm² conductor meets power requirements
• Budget‑conscious installations using copper‑coated aluminium conductors

Key specifications

• Length: 10 metres
• Conductor cross‑section: 1.5 mm²
• Conductor type: CCA (copper‑coated aluminium)
• Construction: single speaker pair, multi‑strand (48x0.20 suggested strand count)
• Jacket: transparent outer sheath for visibility of conductors and markings
• Intended signal: low‑voltage analogue speaker connection

How to use

Route the speaker cable from the amplifier or receiver to the loudspeaker keeping runs as short and direct as practical to minimise signal loss. Strip the jacket and insulation to expose the conductor ends according to the terminal type of the amplifier and speaker, observing correct polarity (positive to positive, negative to negative). Use banana plugs, spade terminals or bare wire connections depending on the speaker and amplifier binding posts. Avoid sharp bends, kinks or pinching, and secure the cable with appropriate clips or conduits for in‑wall or surface installations.

Usage recommendations

For best performance in longer runs or higher‑power systems consider evaluating conductor gauge and material; 1.5 mm² CCA is suitable for typical room‑scale distances but copper conductors and larger cross‑sections reduce resistance for demanding setups. When installing in walls, follow local building codes and fire regulations for cable type and routing.