Extension Cable ShiverPeaks PV4 4 mm² 2 m Red/Black set of 2

ShiverPeaks PV4 extension cable set includes two 2 m leads with a 4 mm² conductor cross-section, supplied in red and black. These low-voltage extension cables are intended for DC power connections and audio/video installations where a thicker gauge is required. The distinct color coding simplifies polarity identification and wiring, while the 4 mm² conductors provide increased current capacity compared with smaller signal cables.

Advantages

The pair of cables offers a balance of flexibility and conductivity suitable for short runs between amplifiers, speakers, batteries and other low-voltage devices. Color-coded insulation reduces the risk of incorrect connections. The 2 m length of each lead provides a compact extension option that is easy to route in racks, housings or vehicle installations. The 4 mm² cross-section supports higher current flows than typical signal cables while remaining manageable for hand termination and standard connectors.

Suitable for

• Connecting car or marine amplifiers and speakers over short distances
• Battery connections and DC power distribution in small systems
• Audio/video equipment wiring that requires thicker gauge conductors
• Temporary or permanent low-voltage extension runs in installations

Key specifications

• Conductor cross-section: 4 mm²
• Length per lead: 2 m
• Quantity: set of 2 leads (red and black)
• Insulation color: red and black for polarity identification
• Application: low-voltage DC power and audio/video wiring

How to use

Strip the insulation at the connection points to the appropriate length for your terminals or connectors, avoiding damage to the conductor strands. Ensure correct polarity by connecting the red lead to the positive terminal and the black lead to the negative terminal. Use properly sized terminals, crimp connectors, or solder joints as required by the installation, and protect exposed connections with heat-shrink tubing or insulated terminals. Route the cables to minimise sharp bends and avoid contact with heat sources or moving parts.

Usage recommendations

For best results, verify that the 4 mm² conductor is suitable for the current draw of your system and the length of the run. When used in automotive or marine environments, secure the cables with appropriate clamps and use corrosion-resistant terminations. If longer runs or higher current capacity are required, select a larger conductor cross-section.