ShiverPeaks USB-A to RJ45 LAN Adapter Cable BS13-52055, 1 Gbps, USB Type A to Ethernet, PVC, 5 m, black

The ShiverPeaks USB-A to RJ45 LAN Adapter Cable BS13-52055 provides a wired Ethernet connection for devices with a USB Type A port. Designed to deliver up to 1 Gbps full-duplex network throughput, this 5 m black PVC-coated cable combines a USB-A plug with an RJ45 connector to enable direct access to wired local area networks. It is intended for scenarios where a stable, low-latency network link is preferred over wireless connections and can be used with laptops, desktops or other USB-A equipped equipment that requires Ethernet access.

Advantages

The adapter cable offers plug-and-play convenience for many modern operating systems, allowing straightforward connection to wired networks without a separate dock or adapter box. Its 5 m length gives flexibility in placement while the PVC outer jacket provides basic mechanical protection and resistance to everyday wear. With support for up to 1 Gbps speeds the cable is suitable for typical office tasks, video calls and general file transfers that benefit from consistent bandwidth and lower latency compared with Wi‑Fi.

Suitable for

• Connecting a laptop or desktop with a USB-A port to a wired Ethernet network
• Network troubleshooting and diagnostics where a direct wired link is required
• Situations where wireless connectivity is unstable or restricted
• Temporary or semi-permanent office and home workstation setups needing a longer cable run (5 m)

When it may not be suitable

This USB-A to RJ45 cable depends on host USB-A support for Ethernet adapters; some devices may require drivers or not support network adapters over USB-A. It is not a replacement for multiport docking stations or adapters that provide additional USB power delivery, video output or multiple peripheral ports. For networks or applications that require speeds above 1 Gbps, such as multi-gigabit environments, this adapter will not provide higher-than-specified throughput.

Key specifications

• Interface: USB Type A (host) to RJ45 (Ethernet)
• Maximum supported network speed: 1 Gbps
• Cable length: 5 meters
• Outer material: PVC jacket, black
• Primary use: Wired Ethernet connectivity for USB-A devices

How to use

Connect the USB Type A plug to an available USB-A port on the host device and insert the RJ45 connector into a network port or wall outlet connected to your local network. Wait for the operating system to recognise the adapter; on many systems this occurs automatically, while some may request driver installation or updates. After the adapter is recognised, configure network settings as needed (DHCP or static IP) and verify link speed and connectivity in the system network status panel. When disconnecting, eject any active network sessions if required by your OS before removing the cable.

What to consider before purchase

• Check that your device supports Ethernet over USB-A and whether drivers are required for your operating system
• Confirm that 1 Gbps network speed meets your performance needs
• Assess whether a 5 m cable length and PVC outer jacket provide the required reach and durability for your environment
• If you need additional ports (power delivery, USB hubs, video), consider a docking solution instead

Usage recommendations

For best results, use the adapter with a compatible USB-A port that supports at least USB 2.0 or higher; ensure the connected network switch or router supports 1 Gbps for full throughput and avoid tight bends or crush points on the 5 m PVC cable to maintain signal integrity and mechanical longevity.