Coaxial Cable ShiverPeaks SAT 1.0/4.6 4-fold shielded CCS >110 dB 100m

ShiverPeaks SAT 1.0/4.6 coaxial cable on a 100 m spool is intended for satellite, TV and RF signal distribution where high shielding and low interference are required. The cable features a stranded copper-clad steel (CCS) center conductor and four-layer shielding that delivers shielding attenuation greater than 110 dB, supporting reliable reception and minimal cross-talk in professional and domestic installations. Its 1.0/4.6 dimensions make it compatible with standard F-type connectors and common SAT/TV cabling practices.

Advantages

The fourfold shield construction provides superior protection against electromagnetic interference and ingress of external signals, improving signal stability for satellite and terrestrial TV systems. The CCS conductor balances mechanical strength with electrical performance, while the overall build and consistent geometry support predictable attenuation and impedance characteristics over the 100 m length. The cable is supplied on a spool for convenient handling during long runs and professional installation work.

Suitable for

• Satellite dish to receiver connections in single and multi-room installations
• Terrestrial TV and FM antenna wiring
• Indoor RF distribution and signal backbone runs in residential and commercial buildings
• Professional cabling where high shielding (>110 dB) is required to reduce interference

When it may not be suitable

This coaxial cable uses a CCS (copper-clad steel) center conductor; in extremely long runs where the lowest possible conductor resistance is required, pure copper conductors may offer marginally lower loss. The cable is intended for indoor and protected routing; it is not specified for continuous outdoor burial or exposure to harsh weather without additional protective conduit or sheathing.

Key specifications

• Cable type: 1.0/4.6 coaxial geometry
• Length: 100 m spool
• Center conductor: copper-clad steel (CCS), stranded
• Shielding: fourfold shield construction
• Shielding attenuation: >110 dB
• Impedance: 75 Ω (typical for SAT/TV coax)
• Applications: satellite, TV, FM and RF distribution

How to use

Unwind the cable from the spool and route it along the planned path, avoiding sharp bends or kinks that could damage the conductor or change impedance. Terminate both ends with appropriate 75 Ω F-type connectors using a compatible coaxial cable stripper and compression or crimp tool; ensure the shielding layers are properly folded back and the dielectric is cut cleanly to maintain good contact. Test the installation with a signal meter or receiver to confirm signal levels and return loss meet expectations before finalizing fixtures and securing the cable.

What to consider before purchase

• Confirm required cable length and add margin for routing and connector space
• Decide whether CCS conductor suits your run length and signal loss requirements or if pure copper is preferred
• Plan for connector type and installation tools (stripper, crimp/compression tool, F-connectors)
• Consider additional protection if cable will be exposed to moisture, UV or outdoor conditions

Usage recommendations

For best performance, keep bend radius greater than five times the cable diameter, avoid running parallel to heavy mains wiring for long distances, and use high-quality compression F-connectors to preserve shielding continuity. After installation, verify signal levels at endpoints and, if necessary, use amplification or re-distribution with professionally rated splitters to maintain signal quality across multiple receivers.