Hydraulic low-profile floor jack Silver Frog 2.5 t, silver

Low-profile hydraulic floor jack Silver Frog 2.5 t in silver finish is designed for lifting vehicles with limited ground clearance. Its compact chassis and low minimum height allow access to pinch welds and other low jacking points on cars and small vans. The hydraulic mechanism provides controlled lifting up to 2.5 tonnes, enabling safe maintenance, wheel changes and light workshop tasks while occupying minimal storage space.

Advantages

The low-profile design ensures access to vehicles with low ride height while the hydraulic system delivers smooth, consistent lifting. A compact footprint and relatively low weight make it easy to position under the vehicle and store in a garage. Solid saddle and reinforced frame provide stable support during lifting operations, and the silver finish resists surface wear associated with workshop use.

Suitable for

• Passenger cars with low ground clearance
• Small vans and light commercial vehicles
• Wheel changes and routine tyre maintenance
• Light-duty workshop tasks and underbody inspections

Key specifications

• Lifting capacity: 2.5 tonnes
• Low minimum height for access to low jacking points
• Hydraulic lifting mechanism for smooth operation
• Compact footprint for easy positioning and storage
• Reinforced frame and solid saddle for stable support

How to use

Position the jack on a flat, level surface and roll it under the vehicle so the saddle aligns with a manufacturer-approved jacking point. Operate the pump lever to raise the saddle until the vehicle is lifted to the required height. Once lifted, place suitable jack stands under the vehicle before performing any work and slowly release hydraulic pressure to transfer load to the stands. After completing maintenance, pump to re-lift slightly if needed, remove the stands, and carefully lower the vehicle using the release valve.

Usage recommendations

Always follow vehicle manufacturer jacking guidelines, use rated jack stands for extended work under the vehicle, check the jack for leaks or damage before use, and ensure the working surface is level and solid. Do not exceed the 2.5 t lifting capacity.