Singularity PowerBoard ARGB connection cable 500 mm SC-PB-LC-ARGB

The Singularity PowerBoard ARGB connection cable 500 mm SC-PB-LC-ARGB is a purpose-built wiring solution for ARGB lighting within PC systems and custom lighting assemblies. At 500 mm length, the cable provides a flexible link between Singularity PowerBoard ARGB controllers, compatible LED strips and motherboard ARGB headers. It carries the necessary ARGB signal and power lines to ensure synchronized addressable RGB lighting across connected components while maintaining a compact and discreet routing profile inside a case or enclosure.

Advantages

This 500 mm ARGB cable is designed for reliable signal transmission and simple integration into PC builds. Its length balances reach and cable management, allowing connections across typical motherboard and controller placements without excessive slack. The cable is compatible with standard 3-pin ARGB headers used in addressable RGB setups and is constructed to minimize signal interference and maintain color accuracy and synchronization between connected devices.

Suitable for

• Connecting Singularity PowerBoard ARGB controllers to ARGB LED strips
• Linking ARGB devices to motherboard 3-pin ARGB headers
• Extending reach between ARGB components in mid-tower and full-tower PC cases

Key specifications

• Cable length: 500 mm
• Connector type: 3-pin ARGB-compatible connector
• Function: Transmits addressable RGB control signal and supply voltage
• Application: Internal wiring for PC ARGB lighting and custom addressable RGB installations
• Construction: Flexible insulated wiring suited for routing within computer cases

How to use

Identify the ARGB output on the Singularity PowerBoard controller and the corresponding 3-pin ARGB header on the target device or motherboard. Align the connector keyed pin orientation to the header to avoid misconnection, then gently press the plug into place until seated. Route the cable along existing cable channels or behind the motherboard tray to minimize obstruction and secure it with cable ties if needed. After connection, power on the system and configure ARGB control settings through the controller or motherboard software to verify color, effects and synchronization.

Usage recommendations

To maintain signal integrity and prevent damage, avoid kinking the cable, pulling on the wires, or placing tight bends near the connector. For best results in multi-device setups, use consistent connector orientations and minimize total cable length between the controller and end devices when possible.