Drill bit for concrete Smart SDS+ 5 mm (17-05210)

Drill bit for concrete Smart SDS+ 5 mm is designed for use with rotary and rotary-percussion drills that accept SDS+ chucks. The 5 mm diameter carbide cutting tip and flute geometry allow controlled removal of dust and efficient penetration into concrete, masonry and similar mineral substrates. The shank fits SDS+ holders for fast insertion and secure locking, making it suitable for typical construction and renovation tasks such as installing anchors, dowels and through-holes.

Advantages

The Smart SDS+ 5 mm concrete drill bit combines a hardened shank and a precision-ground tip to provide consistent drilling performance in reinforced and unreinforced concrete. Its flute profile facilitates debris evacuation to reduce binding and overheating during rotary-percussion operation. Compatibility with SDS+ systems ensures quick bit changes and stable seating in the chuck for accurate hole positioning.

Suitable for

• Drilling holes for plastic or metal anchors and dowels in concrete and masonry
• Creating through-holes for cable routing or pipe passages in walls and floors
• General-purpose drilling where an SDS+ rotary-percussion drill is used

Key specifications

• Drill type: SDS+ concrete drill bit
• Cutting diameter: 5 mm
• Intended materials: concrete, masonry and similar mineral substrates
• Shank type: SDS+ compatible
• Tip: carbide or carbide-tipped geometry for percussion drilling

How to use

Install the drill bit into an SDS+ chuck until it locks in place, ensuring the tool is disconnected from power while changing bits. Select an appropriate drill with rotary-percussion mode for concrete; start at low speed to establish the hole and then apply steady pressure and suitable speed for the material. Withdraw the bit periodically to clear dust when drilling deep holes and use proper clamping or support for loose or thin workpieces. If rebar is encountered, reduce speed and pressure or use a dedicated rebar-cutting bit.

Usage recommendations

Use suitable personal protective equipment (eye protection, dust mask and hearing protection) and a vacuum dust extraction system where possible. Match drill diameter to anchor or dowel specifications and avoid excessive side load to prolong bit life.