Drill Bit Smart SDS+ 14 mm for Concrete, 20-1400300

Smart SDS+ 14 mm drill bit for concrete is designed for use with SDS+ rotary hammers and compatible hammer drills. The 14 mm diameter and hardened tip provide effective penetration in concrete, masonry and similar mineral substrates where a mid-size hole is required. The SDS+ shank system allows quick, secure insertion and efficient transfer of hammering energy for drilling performance in construction, installation and repair work.

Advantages

The carbide-tipped cutting head and reinforced flute geometry ensure fast material removal and extended tool life when drilling concrete and masonry. The SDS+ shank delivers reliable retention in hammer chucks and reduces slippage during heavy-duty use. The bit’s balanced design supports stable drilling with reduced vibration and consistent hole diameter accuracy.

Suitable for

• Drilling 14 mm holes in concrete and reinforced concrete
• Installing anchors, sleeves and dowels in masonry
• Electrical and plumbing installations that require through-holes or anchor points
• Repair and renovation tasks on brick, block and stone substrates

Key specifications

• Diameter: 14 mm
• Shank type: SDS+
• Intended material: concrete, masonry and similar mineral substrates
• Typical use: rotary hammer drilling with hammer action
• Cutting head: carbide or carbide-tipped design for concrete drilling

How to use

Fit the Smart SDS+ drill bit into the SDS+ chuck of a compatible rotary hammer according to the tool manufacturer’s instructions until it locks securely. Mark the drilling point and start drilling at low speed to establish the center, then increase to the recommended working speed and apply steady pressure while allowing the hammer action to do the cutting. Periodically withdraw the bit to clear dust from the hole and to prevent overheating; for deep holes, pull the bit out frequently to remove debris. Use appropriate personal protective equipment such as safety glasses, dust mask and hearing protection.

Usage recommendations

For best results in reinforced concrete, use a rotary hammer with sufficient impact energy and select a drilling rhythm that allows dust evacuation. Avoid excessive lateral force to prevent premature wear. Match hole depth to anchor or fastener length and clean holes before inserting fixings.