Diamond Hole Saw Sourcing DISTAR ROCKET 55 x 45-6 mm with M14 shank

Diamond Hole Saw Sourcing DISTAR ROCKET 55 x 45-6 mm with M14 shank is a precision diamond cutting tool designed for drilling circular openings in hard and brittle surfaces. With a 55 mm cutting diameter and a 45 mm cutting depth, this hole saw provides stable, accurate performance when creating holes for pipes, fittings, vents and electrical boxes. The 6 mm segment height combines cutting efficiency with durability, while the M14 shank enables direct mounting to compatible rotary tools or drill adapters for controlled operation on ceramics, porcelain, tiles and natural stone.

Advantages

The segmented diamond rim ensures fast material removal and reduced load on the tool, providing consistent cutting performance across the segment height. The combination of 55 mm diameter and 45 mm depth offers a balance between reach and stability, allowing deeper cuts without excessive wobble. The M14 shank provides wide compatibility with common angle grinders and rotary adapters, simplifying attachment and setup. The design reduces dust build-up at the cutting edge and supports smoother hole edges in brittle materials.

Suitable for

• Drilling holes in ceramic and porcelain tiles for plumbing and electrical fixtures
• Creating openings in natural stone and engineered stone for installations
• Cutting round penetrations in wall and floor tiles during renovation work
• Making precise circular cuts in brittle cladding and facade materials

Key specifications

• Cutting diameter: 55 mm
• Cutting depth: 45 mm
• Diamond segment height: 6 mm
• Shank type: M14 (for use with compatible rotary tools or adapters)
• Suitable materials: ceramic, porcelain, glazed tile, natural stone, engineered stone

How to use

Mount the diamond hole saw onto an M14-compatible rotary tool or adapter according to the tool manufacturer's instructions. Secure the workpiece and, where possible, mark the center of the hole. Start drilling at low speed to establish a guide groove, then increase speed moderately while maintaining steady pressure. Use water cooling or a continuous light stream of water to reduce heat and remove debris when working on ceramic, porcelain or stone surfaces. Withdraw periodically to clear slurry and check progress, maintaining a perpendicular orientation for an accurate circular cut.

Usage recommendations

For best results, use consistent cooling and moderate speed; avoid excessive pressure that can cause chipping in brittle materials. When drilling large or deep holes, consider progressive drilling from both sides of the workpiece if access allows. Inspect the diamond segments before use and replace the hole saw if segments are worn to maintain cutting quality and safety.