Sourcing collated spiral nails FAC 2.50×60 mm for pneumatic nailer, galvanized, coil pack

Sourcing collated spiral nails FAC 2.50×60 mm for pneumatic nailer, galvanized, coil pack are spiral-shank fasteners designed for high-volume timber and construction work. With a 2.50 mm diameter and 60 mm length, these nails offer increased withdrawal resistance compared with smooth-shank nails, making them suitable for structural connections where secure holding is required. The galvanized finish provides basic corrosion resistance for use in exterior and interior projects where moderate exposure to moisture or humidity is expected. Delivered in a coil format, the pack is intended for compatible pneumatic or coil nailers to reduce reloading time on continuous jobs.

Advantages

Spiral-shank design increases holding power by creating a screw-like engagement in wood fibers, improving resistance to pull-out under load. The 2.50×60 mm dimensions balance penetration depth and head retention for common framing and sheathing tasks. Galvanization helps protect the steel from surface corrosion and extends service life in many construction environments. Coil packaging supports efficient operation with pneumatic coil nailers, enabling rapid sequential nailing and fewer interruptions during high-volume work.

Suitable for

• Framing timber structures and wall studs
• Sheathing and subfloor installation
• Decking and exterior timber assemblies with moderate exposure
• Roof battening and purlin fastening
• High-volume fastening tasks using pneumatic or coil nailers

Key specifications

• Shank type: spiral (spiral-shank) for increased withdrawal resistance
• Diameter: 2.50 mm
• Length: 60 mm
• Finish: galvanized for corrosion resistance
• Packaging: coil format compatible with pneumatic/coil nailers
• Head: suitable for coil nailer heads (flat/standard head profile)

How to use

Load the coil pack into a compatible pneumatic coil nailer following the tool manufacturer's instructions and safety procedures. Adjust air pressure and depth-of-drive settings on the nailer to match the 2.50×60 mm nail dimensions and the density of the timber or substrate being fastened. Position the nailer square to the work surface and drive nails at the recommended spacing for the application to ensure secure connections. Allow for adequate penetration without overdriving the head into the timber surface.

Usage recommendations

For best results, verify nailer compatibility with spiral-shank coil nails and set pneumatic pressure according to material thickness. Use galvanized spiral nails for projects with occasional moisture exposure; for continuous or heavy exterior exposure, consider stainless or hot-dip galvanized alternatives. Store coils in a dry place to maintain the galvanized finish and avoid prolonged exposure to corrosive environments.