Audio cable SSQ JMPJMP7 — mono jack to mono jack, 7 m, black

SSQ JMPJMP7 is a 7-meter mono jack-to-mono jack audio cable in black designed to carry a single-channel audio signal between compatible 6.35 mm (1/4") TS connectors. Built for simple instrument and line-level connections, this cable suits stage, studio, rehearsal and home environments where a dependable mid-length mono link is needed. The cable length provides flexibility while remaining manageable for routing and setup.

Advantages

The cable offers a straightforward, low-complexity connection that minimizes signal routing errors and is easy to install. Its single-channel design suits instruments and mono devices, enabling direct, noise-resistant transmission when used with properly grounded equipment. The 7 m length balances reach and signal integrity for typical stage and studio arrangements. The black exterior provides a discreet appearance and pairs well with common audio setups.

Suitable for

• Connecting electric guitars, basses or keyboards to amplifiers or DI boxes
• Linking mono line-level devices such as mixers, preamps or outboard processors
• Stage and rehearsal setups requiring mid-length patching
• Home studio or practice environments where a single-channel connection is sufficient

Key specifications

• Connector type: mono 6.35 mm (1/4") TS to mono 6.35 mm (1/4") TS
• Cable length: 7 m
• Channels: single (mono)
• Colour: black
• Typical use: instrument and line-level audio connections

How to use

Insert one mono jack into the output of the source instrument or device and the other jack into the input of the amplifier, mixer or processor. Ensure connectors are fully seated to maintain a stable connection. Avoid sharp bends near the connector ends and keep the cable clear of high-traffic areas to reduce mechanical wear. When not in use, coil the cable loosely to prevent kinks and store in a dry place.

Usage recommendations

For best results, use this mono cable with properly grounded equipment and avoid running it in parallel with mains power cables to minimise hum. If using with balanced systems, use a dedicated balanced cable instead of a mono TS lead to preserve noise rejection.