Hand cable end cutters STANLEY FATMAX VDE 1000V 160 mm, chromium-vanadium steel, red-yellow handle

STANLEY FATMAX VDE 1000V end cable cutters are hand tools intended for cutting wires and cable ends in electrical installation, maintenance and repair. With a length of 160 mm and a compact weight of approximately 222 g, these cutters combine a chromium‑vanadium steel cutting head with insulated red‑yellow handles rated for work on live circuits up to 1,000 V. The design emphasizes precision cutting, durability of the hardened cutting edges and safe handling for tasks near energized equipment.

Advantages

These end cutters feature a chromium‑vanadium steel construction with heat treatment and hand‑ground cutting edges for long service life and accurate cuts. The bi‑material red‑yellow handles are insulated and rated to 1000 V, providing protection when working close to live conductors. The tool is compact and balanced for controlled, precise cutting, and the joint assembly is designed for smooth operation under repeated use. Individual testing to high voltage standards supports safe use in electrical environments.

Suitable for

• Cutting single conductors, stranded wire and cable ends during electrical installation
• Maintenance and repair work on control panels and wiring harnesses
• Precision cutting tasks in confined spaces where a compact 160 mm tool is required
• Use by professional electricians and trained technicians working near live circuits up to 1,000 V

Key specifications

• Overall length: 160 mm
• Material: Chromium‑vanadium steel cutting head
• Handle: Bi‑material insulated handles in red and yellow
• Electrical insulation rating: 1000 V (suitable for work on circuits up to 1,000 volts)
• Weight: approx. 222 g
• Cutting edge: Hand‑ground, induction‑hardened for durability
• Operational temperature range: suitable for typical site conditions (resistant to low and high temperatures)

How to use

Position the cutter jaws around the conductor or cable end to be cut, ensuring the material is centered on the cutting edges. Apply steady hand pressure to close the handles until the conductor is severed. For insulated cables, strip insulation as required before cutting thick cores. Observe standard safety procedures for electrical work, including de‑energizing circuits when possible and wearing appropriate personal protective equipment. Use the compact length to access tight spaces and perform controlled, single‑pass cuts for a clean finish.

Usage recommendations

Before use, verify the insulation integrity of the handles and that the tool is certified for 1000 V working voltage. Do not use the cutters on live circuits above the rated voltage. Keep cutting edges clean and periodically inspect for wear; replace the tool if the insulation is damaged or the cutting performance degrades. Store in a dry place to prevent corrosion of the steel components.