Drill bit STANLEY STA52011 — 5 mm diameter, 90 mm length, 1 pc

Single STANLEY STA52011 drill bit with a 5 mm cutting diameter and 90 mm overall length. This straight-shank twist bit is supplied as one piece and is intended for use with standard electric or cordless drills for routine drilling tasks in wood and similar materials. The bit is designed for making precise 5 mm holes needed in repair work, joinery, furniture assembly and general DIY or construction jobs where a consistent hole diameter and straight drilling are required.

Advantages

The STANLEY STA52011 drill bit offers a defined 5 mm cutting diameter and a 90 mm length that provides adequate reach for most common woodworking and repair tasks. Its single-piece supply makes it convenient to select and fit into a drill chuck quickly. The straight-shank design is compatible with standard chucks and drill drivers, supporting stable rotation and consistent hole quality. The bit’s dimensions are suitable for precise positioning and repeatable drilling when installing fasteners, dowels or creating guide holes.

Suitable for

• Drilling 5 mm diameter holes in wood for dowels, screws or fasteners
• General carpentry and joinery tasks requiring a 5 mm pilot or through hole
• Repair and maintenance jobs where a single, accurate 5 mm hole is needed
• DIY projects and small construction tasks with wooden components

Key specifications

• Cutting diameter: 5 mm
• Overall length: 90 mm
• Recommended material: wood
• Quantity: 1 piece

How to use

Install the 5 mm STANLEY STA52011 drill bit securely into the drill chuck and tighten according to the drill manufacturer’s instructions. Select an appropriate drill speed for the wood type being drilled and, if necessary, clamp the workpiece to prevent movement. Start drilling at a steady, controlled feed rate, keeping the drill perpendicular to the surface for a straight hole. Withdraw the bit periodically on deeper holes to clear chips and reduce heat buildup. After use, remove the bit and store it in a suitable holder to protect the cutting edge.

Usage recommendations

Use the drill bit primarily in wood and similar soft materials; avoid applying excessive side pressure. For cleaner holes in softer woods, reduce speed and use light backing or masking to prevent splintering on exit. Inspect the bit before use for any damage and replace if the cutting edge is worn.