Spade drill bit STANLEY 5287956, diameter 1.6 cm, 1 piece

STANLEY 5287956 spade drill bit, diameter 1.6 cm, single-piece design for use with standard hand and power drills. The flat paddle-shaped blade clears material quickly to create straight, clean 16 mm holes in wood and similar soft materials. This spade-style bit is intended for general carpentry, joinery and installation tasks where rapid removal of wood fibers and accurate hole positioning are required.

Advantages

The single-piece construction provides rigidity and reduces wobble during drilling, helping to maintain a straight bore. The wide paddle profile removes chips efficiently to speed up drilling in timber and composite wood products. The 1.6 cm cutting diameter produces consistent 16 mm holes suitable for common fasteners and fittings. Supplied as a single unit, the bit is straightforward to install and replace in drill chucks.

Suitable for

• Drilling through softwoods and hardwoods
• Creating 16 mm holes for dowels, conduits or cable passages
• General carpentry and joinery tasks
• On-site installation work and repair jobs

Key specifications

• Type: Spade (paddle) drill bit
• Cutting diameter: 1.6 cm (16 mm)
• Material compatibility: Wood and similar soft materials
• Quantity: 1 piece

How to use

Secure the STANLEY 5287956 spade bit in the drill chuck and tighten firmly. Mark the drilling point on the workpiece and, when possible, use a center punch or pilot mark to prevent walking. Start drilling at low speed to establish the hole, then increase speed as the bit cuts deeper; apply steady, moderate pressure and allow the paddle to remove chips. For through-holes, back the bit out occasionally to clear debris and avoid overheating. After use, clean resin or dust from the blade and store the bit dry.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses and hearing protection. Match drill speed and feed to the wood type—slower speeds for hardwoods and higher speeds for softwoods—to extend bit life and achieve cleaner holes. Ensure the workpiece is clamped securely to prevent movement during drilling.