Drill bit STANLEY STA54152 for rotary hammer, 7 mm x 160 mm, 1 pc

STANLEY STA54152 drill bit for rotary hammer, 7 mm x 160 mm, 1 pc is designed for drilling medium-depth holes in masonry and concrete when used with a compatible rotary hammer. The single-piece 7 mm diameter bit and 160 mm overall length deliver a balance between reach and control for professional tradespeople and home users who need accurate 7 mm holes in walls, blocks or similar substrates.

Advantages

This STANLEY drill bit features an SDS-plus shank for secure, tool-compatible attachment and reduced slipping during hammer drilling. Its 7 mm diameter provides consistent hole size for anchor bolts, dowels and fasteners while the 160 mm length allows working through common wall thicknesses and finishes. The bit is intended for use in concrete and other masonry materials and is supplied as a single unit for easy inventory and replacement.

Suitable for

• Drilling 7 mm holes for anchors, dowels and fasteners in concrete and masonry
• Medium-depth drilling in walls and blocks
• Professional construction and renovation tasks requiring precise 7 mm holes
• DIY projects at home where a rotary hammer with SDS-plus is available

Key specifications

• Diameter: 7 mm
• Overall length: 160 mm
• Shank type: SDS-plus
• Intended materials: concrete and masonry
• Package quantity: 1 piece

How to use

Install the drill bit into the rotary hammer’s SDS-plus chuck until it locks. Select the hammer-drilling mode on the tool and position the bit perpendicular to the work surface. Apply steady pressure while allowing the tool’s hammer action to do the cutting; avoid excessive force that can overheat or break the bit. Withdraw periodically to clear dust when drilling medium-depth holes. After drilling, remove the bit by pulling it from the chuck according to the rotary hammer manufacturer’s instructions.

Usage recommendations

Use appropriate personal protective equipment such as safety glasses, hearing protection and dust mask. Match drill speed and hammer impact settings to the material: lower speeds and consistent hammer action for dense concrete, moderate settings for softer masonry. Replace the bit if you notice excessive wear, bending or loss of cutting performance.