HCS Wood Hole Saw Set STANLEY STA81005 – diameters 25, 32, 38, 45, 50, 56, 62 mm

Set of HCS wood hole saws from STANLEY with seven cutting diameters: 25 mm, 32 mm, 38 mm, 45 mm, 50 mm, 56 mm and 62 mm. The STA81005 set is designed to cut circular holes in solid wood, plywood and other wood-based materials. Blades are made from high carbon steel (HCS) for effective cutting of soft and semi-hard timber; the set is intended for use with hand drills and drill drivers that accept a standard arbor.

Advantages

The hole saws in this set provide a range of common diameters for plumbing, electrical and carpentry work, reducing the need to change tools. HCS construction balances cutting performance and affordability for wood applications. The set offers quick hole cutting with clean edges when used at appropriate speeds and with steady feed pressure. Compatibility with standard arbors and drill drivers makes the set versatile for both professional tradespeople and DIY users.

Suitable for

• Drilling circular holes for door hardware and locks in wooden doors
• Creating cable and conduit entries for electrical and networking installations
• Cutting openings for plumbing fixtures and pipe penetrations through timber
• Making recesses and passthroughs in cabinetry and furniture projects
• General workshop and site drilling where varied hole diameters are required

Key specifications

• Material: high carbon steel (HCS) blades suitable for wood and wood-based materials
• Included diameters: 25 mm, 32 mm, 38 mm, 45 mm, 50 mm, 56 mm, 62 mm
• Compatible with most hand drills and cordless drill drivers using a standard arbor
• Designed for cutting circular holes in solid wood, plywood and similar substrates

How to use

Fit the appropriate hole saw diameter onto a compatible arbor and secure it in the drill chuck according to the arbor manufacturer’s instructions. Mark the centre point of the hole on the workpiece and, if available, use a pilot bit to stabilize the cut. Start drilling at low speed to establish the cut, then increase speed while maintaining steady pressure and alignment. Clear chips periodically to prevent clogging and reduce heat buildup. After cutting, deburr the hole edges as needed for a clean finish.

Usage recommendations

Use cutting speeds and feed pressure appropriate for the wood species; lower speeds for hard or knotty timber. For prolonged life of the HCS teeth, avoid cutting metals or masonry. Wear eye and hand protection and secure the workpiece before drilling. Replace worn or damaged blades to maintain cutting quality and safety.