Strip light Synergy21 S21-LED-F00004 — Universal LED strip, 5000 mm, warm white, 300 LEDs, 12 V, 72 W

Synergy21 S21-LED-F00004 is a universal LED strip light 5000 mm long that provides warm white illumination from 300 LEDs. Designed for both indoor and outdoor ambience lighting, the strip operates on 12 V DC with a total power consumption of 72 W. Its slim profile (12.9 mm × 4.8 mm) and wide operating temperature range of -25 to 60 °C make it suitable for accent, cove and decorative installations that require continuous, even light along a length of five metres.

Advantages

The LED strip offers uniform warm white light from a dense array of 300 LEDs, ensuring smooth illumination without pronounced hotspots. Low-voltage 12 V operation increases compatibility with common LED drivers and 12 V systems while the 72 W power rating defines the expected energy demand for a full 5 m run. A slim cross-section allows installation in narrow profiles or behind coves, and the included adhesive backing simplifies surface mounting. The specified operating temperature range supports use in many indoor and protected outdoor environments.

Suitable for

• Accent lighting for shelves, displays and architectural details
• Cove and perimeter lighting in living rooms and commercial spaces
• Under-cabinet and task-adjacent mood illumination
• Decorative lighting for covered outdoor areas and patios
• Continuous runs where a 5 m length is required without frequent joins

Key specifications

• Length: 5000 mm
• LED quantity: 300 LEDs
• Light colour: warm white
• Nominal voltage: 12 V DC
• Power consumption (full length): 72 W
• Cross-section (W × H): 12.9 mm × 4.8 mm
• Operating temperature range: -25 °C to 60 °C
• Mounting: self-adhesive backing for surface installation

How to use

Measure and plan the installation route ensuring access to a suitable 12 V DC power supply and correct polarity. Clean and dry the mounting surface before removing the protective film from the adhesive backing and press the strip into place along the intended run. For runs longer than a single 5 m strip or for parallel installations, use appropriate 12 V drivers whose combined output meets the total wattage demand. Cut only at designated cut points if shorter segments are required, and observe correct connectors or soldering techniques when joining segments.

Usage recommendations

Use a compatible constant-voltage 12 V LED driver rated to cover the 72 W load with adequate headroom (recommended driver capacity approx. 90 W) and protect outdoor or damp installations by installing the strip in covered or IP-rated channels. Avoid bending the strip sharply across the LED pads; maintain recommended bend radii and cut only at marked points. For extended service life, ensure adequate ventilation around the power supply and limit exposure to direct weather unless additional protection is provided.