Ceiling strip light Synergy21 S21-LED-NB00113, 5,000 mm, 300 LEDs, 90 W, 24 V, adhesive-mount

Synergy21 S21-LED-NB00113 is a 5,000 mm ceiling strip light designed for indoor linear illumination. The strip contains 300 LEDs that deliver selectable blue, green, red and warm white colours. With a slim profile and adhesive mounting, this 90 W, 24 V fixture is intended for installation in coves, under cabinets or other architectural accents where continuous, low-profile lighting is required. The operating temperature range supports typical indoor environments.

Advantages

The Synergy21 strip offers long linear coverage in a single 5 m length, reducing the need for multiple joins and ensuring more uniform light distribution. Its slim dimensions allow discreet installation in narrow channels, coves or behind trims. Adhesive-mount attachment simplifies placement without visible fasteners, while the 24 V operating voltage and 90 W power draw provide stable illumination suitable for extensive runs. Multiple colour options (blue, green, red, warm white) enable accent or mood lighting and straightforward integration with controllers that support mixed-colour LED strips.

Suitable for

• Cove and perimeter lighting in residential and commercial interiors
• Under-cabinet task or accent illumination in kitchens and workspaces
• Display, shelving and retail accent lighting for products
• Architectural detailing and indirect lighting behind trims or panels

Key specifications

• Length: 5,000 mm
• LED count: 300 LEDs
• Available light colours: Blue, Green, Red, Warm white
• Power consumption: 90 W
• Operating voltage: 24 V
• Operating current (approx.): 3.75 A
• Profile dimensions: 12 mm × 2.2 mm
• Mounting method: Adhesive tape
• Intended location: Indoor use
• Operating temperature range: −25 °C to 60 °C

How to use

Prepare a clean, dry mounting surface free of dust, grease and paint residues. Measure and cut the installation path if necessary following the manufacturer’s cut points, then route the strip so LEDs face the area to be illuminated. Peel the protective backing from the adhesive tape and press the strip firmly onto the mounting surface along its full length to ensure secure adhesion. Connect the strip to a compatible 24 V, 3.75 A (or higher current-capable) power supply and any required LED controller according to wiring instructions. Verify polarity before powering and test colours and brightness settings after installation.

Usage recommendations

For best adhesion, allow the mounting surface to reach room temperature and press the tape firmly for several seconds; use additional mechanical fasteners if installing in high-vibration areas. Use a suitable 24 V power supply with enough current capacity and consider a compatible LED controller for colour selection and dimming. Observe the specified operating temperature range and avoid exposure to moisture to ensure long-term performance.