Pipe cutter with reamer TOYA 78375 — cutting capacity 3–30 mm

Handheld pipe cutter TOYA 78375 — cutting capacity 3–30 mm combines a compact rolling cutter mechanism with an integrated reamer to prepare and finish pipes quickly and accurately. The tool is designed for manual use on metal and plastic tubing within the 3–30 mm diameter range and is suitable for plumbing, HVAC and general installation or repair tasks where a small, reliable pipe cutter is needed.

Advantages

The rolling cutter provides controlled, even cutting pressure to reduce deformation of the pipe while the adjustable clamping frame accommodates a wide range of diameters. The built-in reamer allows immediate deburring and smoothing of inner edges after cutting, eliminating the need for a separate tool. Its compact handheld design facilitates use in confined spaces and improves handling during repetitive operations.

Suitable for

• Cutting and preparing copper, aluminum and plastic tubing with diameters from 3 mm to 30 mm
• Plumbing repairs and new pipe installations in residential and commercial buildings
• HVAC maintenance where compact manual tools are required for tight areas
• On-site pipe preparation for fittings, compression joints and soldering

Key specifications

• Cutting capacity: 3–30 mm diameter
• Integrated reamer for deburring and inner-edge smoothing
• Rolling cutter mechanism for precise, low-deformation cuts
• Compact handheld construction for restricted spaces
• Manual operation; no power source required

How to use

Position the pipe in the cutter so the cutting wheel aligns with the desired cut line and tighten the frame until the wheel contacts the pipe. Rotate the tool around the pipe while gradually tightening to maintain consistent pressure until the pipe is severed. After cutting, deploy the integrated reamer into the pipe bore and rotate to remove burrs and smooth the inner edge. Wipe the pipe surfaces clean before assembly or joining.

Usage recommendations

Use steady, incremental tightening during cutting to avoid over-compression of soft tubing. Inspect the cutting wheel and reamer regularly and replace them if worn to maintain clean cuts and effective deburring. Wear appropriate hand protection and eye protection when cutting metal pipes.