RCA (Cinch) cable UGREEN UGR314BLK — 2×RCA to 2×RCA, 1.5 m, black

The UGREEN UGR314BLK is an unbalanced analog RCA (Cinch) audio cable with two RCA plugs on each end and a 1.5 m black jacket. It is designed for carrying stereo line-level signals between consumer audio and video components such as CD players, amplifiers, AV receivers, TVs and DACs. The cable provides a simple, direct connection for left/right analog audio channels and is suitable for typical home and small studio audio setups.

Advantages

This 2×RCA to 2×RCA cable offers reliable, low-complexity connectivity for stereo line-level signals. The 1.5 m length balances reach and signal integrity for common placement of devices, while the black outer jacket blends with most AV systems. The cable’s construction is intended to minimize handling noise and ensure consistent contact at RCA connectors for straightforward, user-friendly installation.

Suitable for

• Connecting CD players, cassette decks or media players to amplifiers or powered speakers
• Linking AV receivers or integrated amplifiers to TVs or set-top boxes with analog outputs
• Patch connections between audio interfaces, mixers or DACs and consumer-level equipment
• Replacing worn or missing short interconnect cables in home audio systems

When it may not be suitable

The UGREEN UGR314BLK is an unbalanced analog cable intended for stereo line-level signals; it is not suitable for balanced connections, professional AES/EBU digital audio, or microphone-level signals without appropriate preamps. It also does not carry digital formats such as HDMI or optical audio, so it is not a replacement for digital interconnects when digital signal integrity or multi-channel formats are required.

Key specifications

• Connector configuration: 2×RCA (male) to 2×RCA (male)
• Cable length: 1.5 m
• Signal type: Unbalanced analog stereo line-level
• Color: Black
• Typical use: Consumer audio/video interconnect

How to use

Connect the red plug to the right-channel RCA jack and the white (or black) plug to the left-channel RCA jack on both source and destination devices. Ensure both devices are powered off or volume is turned down before connecting to avoid pops or transient noise. After connecting, power on the devices and select the correct input on the receiver or amplifier. Adjust levels on the source and destination to achieve the desired playback volume and balance.

What to consider before purchase

• Verify that both your source and destination devices have unbalanced RCA inputs/outputs
• Confirm that 1.5 m length is sufficient for your device placement and routing needs
• Check whether an unbalanced analog cable meets your audio quality and interference requirements; consider balanced or digital options if needed

Usage recommendations

Route the cable away from power supplies and mains wiring to reduce potential hum or interference. Use snug but not over-tight connections at RCA jacks; if you experience intermittent contact, inspect connectors for debris or wear and replace if necessary.