Hole saw for concrete Verto 80 mm model 60H280

The Verto Hole Saw for Concrete 80 mm (model 60H280) is a circular cutting tool engineered for drilling clean, round holes with an 80 mm nominal diameter in concrete and similar masonry materials. Designed to be used with rotary drills and hammer drills equipped with a compatible arbor, this hole saw enables installation tasks such as running pipes, conduits and fixing anchors or fixtures. The tool’s geometry and cutting edge are matched to the demands of abrasive, hard substrates, providing predictable hole size and fit for mechanical and electrical installations.

Advantages

The hole saw delivers consistent 80 mm diameter holes in concrete with reduced chipping when used at appropriate speeds and with correct drill type. Its construction supports efficient material removal and extended cutting life when paired with suitable pilot drills and proper cooling or intermittent operation. Compatibility with common drill arbors allows straightforward mounting and a stable drilling operation for alignment-sensitive installations.

Suitable for

• Drilling 80 mm holes in concrete walls and floors
• Installing pipes, conduits and cable passages
• Creating openings for anchors, sleeves and fixture mounts
• Electrical and plumbing penetrations in masonry structures

Key specifications

• Nominal cutting diameter: 80 mm
• Intended material: concrete and similar masonry
• Tool type: circular hole saw for use with rotary and hammer drills
• Typical mounting: arbor attachment compatible with standard drill chucks

How to use

Securely attach the hole saw to a compatible arbor and fit the assembly into a rotary or hammer drill according to the drill manufacturer’s instructions. Mark the center of the intended hole and use an appropriate pilot drill or guide to position the hole saw. Start drilling at low speed to establish the cut, then apply steady pressure and increase speed as the cutting progresses, allowing the tool to remove material without binding. For deep cuts or dense concrete, withdraw occasionally to clear debris and allow the cutter to cool. Finish the hole by backing the tool out while the drill is running slowly to avoid irregular edges.

Usage recommendations

Use appropriate personal protective equipment, including eye protection, dust mask and hearing protection. For optimal performance, match drill type and speed to the substrate, use a pilot drill where applicable, and avoid excessive axial force to prevent premature wear. When working in reinforced concrete, proceed cautiously and consider specialized diamond cutters if prolonged cutting is required.