Drill Bit Verto SDS+ 16 mm for Concrete, model 60H643

Verto SDS+ 16 mm drill bit model 60H643 is a masonry drilling accessory made for use with SDS+ rotary hammers. This straight shank bit is engineered to produce clean 16 mm diameter holes in concrete, brick and similar mineral materials. It is suitable for common installation and fastening tasks such as anchor fixing, conduit and pipe entry, and drilling for dowels or through-holes where a reliable, consistent hole size is required.

Advantages

The drill bit features an SDS+ compatible shank for quick, secure insertion into compatible rotary hammer chucks and efficient impact energy transfer. Its carbide tip and flute geometry are designed to remove dust and debris while maintaining hole accuracy in dense materials. The 16 mm diameter provides compatibility with standard anchors and fasteners used in building and installation work, offering repeatable performance for professional and DIY applications.

Suitable for

• Drilling 16 mm holes in concrete and reinforced concrete
• Anchor and plug installation in masonry
• Creating passages for electrical conduit and plumbing
• Preparing holes for structural and non-structural fixings

Key specifications

• Drill diameter: 16 mm
• Shank type: SDS+ compatible straight shank
• Intended material: concrete, brick and similar mineral substrates
• Tip material: carbide cutting tip for masonry drilling
• Primary use: rotary hammer (hammer drilling) operation

How to use

Secure the Verto SDS+ 16 mm bit into the SDS+ chuck of a suitable rotary hammer according to the tool manufacturer's recommendations. Mark the drilling position and start at low rotation to locate the point, then apply steady pressure while engaging the hammer function to advance the bit into concrete. Periodically withdraw the bit to clear dust and allow the flutes to remove debris for consistent progress. Use appropriate personal protective equipment, such as eye and hearing protection and a dust mask, when drilling.

Usage recommendations

For best results, match the drill speed and hammer settings to the material density and use water or a dust extraction system only if recommended by your tool manufacturer. Inspect the carbide tip for wear before prolonged use and replace the bit if cutting performance declines to maintain hole accuracy and reduce stress on the tool.