Test lead set Voltcraft MS 4100S — 1.00 m leads with 4 mm lamella plug

Voltcraft MS 4100S test lead set includes 1.00 m flexible leads terminated with 4 mm lamella plugs designed for reliable electrical measurements and safe connection to compatible test instruments. The leads provide stable contact and consistent electrical conductivity, making them suitable for laboratory benches, service workshops and field measurement tasks where 4 mm lamella connectors are required.

Advantages

The leads are manufactured to provide flexible handling and long-term mechanical durability while maintaining good electrical contact through 4 mm lamella plugs. The 1.00 m length balances reach and control for routine measurement tasks. Insulation and plug design reduce the risk of accidental disconnection during measurement, and the construction supports repeated insertion and removal without significant loss of contact quality.

Suitable for

• Connection to multimeters with 4 mm lamella sockets
• Laboratory measurement setups and bench testing
• Electronics repair and diagnostics in workshops
• Field measurements and on-site testing tasks

Key specifications

• Lead length: 1.00 m
• Connector type: 4 mm lamella plug
• Lead construction: flexible insulated wire for routine test use
• Typical use: measurement and test equipment connection

How to use

Insert the 4 mm lamella plugs firmly into the compatible sockets of the measuring instrument and the device under test, ensuring correct polarity where applicable. Route the leads to avoid sharp bends and mechanical strain; secure them if necessary to prevent accidental tugging. Perform measurements following the operating instructions and safety procedures of the measuring instrument being used. After use, disconnect the plugs by pulling on the insulated plug body rather than the cable and store the leads in a dry place.

Usage recommendations

Use the test leads with instruments that accept 4 mm lamella connectors and observe the maximum ratings and safety instructions of the measuring device. Regularly inspect insulation and plug surfaces for wear or damage and replace the leads if any deterioration that could affect safety or contact quality is present.