Bar clamp Vorel TOYA 37800, iron and wood construction, 800 mm length

The Vorel TOYA 37800 bar clamp is a manual clamping tool designed for woodworking and light metalworking tasks. With an 800 mm usable length and a combination of iron components and a wooden handle, this clamp delivers steady, adjustable pressure for gluing, assembly and holding workpieces during cutting, sanding or joining operations. Supplied as a single-piece tool, it is intended for workshop and on-site use where reliable clamping and simple operation are required.

Advantages

The iron jaws and stable tinned steel rail provide durable contact surfaces and consistent alignment under load. A pressure screw with a swinging pressure plate helps distribute clamping force evenly across workpieces, while the lacquered wooden handle with a reinforced metal ferrule enables effective tightening with a comfortable grip. The tool’s straightforward design reduces setup time and allows controlled manual pressure for delicate and robust tasks alike.

Suitable for

• Clamping boards and panels for gluing and assembly
• Holding components during routing, sanding or planing
• Temporary fixturing in joinery and carpentry work
• Light metalworking operations where manual clamping is sufficient

Key specifications

• Usable length: 800 mm
• Jaw material: cast iron
• Rail material: tinned steel
• Pressure mechanism: screw with swinging pressure plate
• Handle: lacquered wooden handle with metal reinforcement
• Package quantity: 1 piece

How to use

Position the clamp so the fixed jaw contacts one side of the workpiece and the movable jaw rests against the opposite side. Slide the movable jaw along the rail to approach the workpiece, then turn the pressure screw to apply clamping force. Use the swinging pressure plate to ensure even contact and avoid point loads on the material. Adjust pressure gradually to achieve secure holding without damaging the workpiece. After finishing the task, fully release the screw and slide the movable jaw away to remove the clamp.

Usage recommendations

For reliable results, clean the rail and jaw contact surfaces of dust and glue residue before use. Avoid over-tightening on thin or delicate materials; use protective pads between the jaws and the workpiece when necessary. Inspect the wooden handle and metal reinforcement periodically for wear, and store the clamp in a dry place to minimize corrosion of iron components.