Pipe wrench Vorel 55211, length 425 mm, 1 pcs

Vorel 55211 is a 425 mm pipe wrench designed for gripping and turning pipes and fittings. Supplied as a single unit, the tool has serrated jaws that provide a firm hold on round and hexagonal pipe surfaces and a long handle that increases leverage for more efficient tightening and loosening. The wrench is intended for plumbing, installation and maintenance tasks where controlled torque and secure grip are required.

Advantages

The serrated jaw profile reduces slippage and improves contact area on metal and plastic pipes. The extended 425 mm handle delivers higher mechanical advantage to make stubborn fittings easier to loosen without excessive force. Constructed from durable materials, the wrench resists wear under repeated use and maintains jaw alignment for consistent performance. Supplied as a single piece, it is compact enough for storage in a toolbox yet long enough to access fittings in typical residential and light commercial installations.

Suitable for

• Plumbing repair and installation work on water and heating systems
• Tightening and loosening threaded pipes and couplings
• Maintenance tasks in workshops and service vehicles
• Alignment and repositioning of pipework during assembly

Key specifications

• Overall length: 425 mm
• Jaw type: serrated gripping jaws suitable for round and hex profiles
• Quantity: 1 piece
• Handle: long handle for increased leverage
• Intended use: manual pipe gripping and turning

How to use

Select the proper orientation so the serrated jaws engage the pipe surface. Position the wrench on the pipe with the jaws fully seated, then apply steady force to the handle in the required direction to tighten or loosen the fitting. For best control, maintain a firm two-handed grip when higher torque is needed and avoid sudden jerks; use gradual pressure to prevent damage to the pipe or fitting. After use, clean any debris from the jaw surfaces and store the wrench in a dry place to reduce corrosion.

Usage recommendations

Use the wrench within its mechanical limits and avoid using extension bars that could overload the tool. For soft or finished surfaces, consider protective pads between the jaws and the pipe to reduce marring. Inspect the jaws regularly for wear and replace the tool if serrations are significantly worn to ensure safe and effective operation.