Screwdriver bit set Vorel 66113 — 1/4" drive, 60 mm length, 8 pieces

Vorel 66113 is a set of eight 1/4" (6.35 mm) hex-drive screwdriver bits, each 60 mm in length. The bits are identical and intended for use with hand drivers, bit holders and powered screwdrivers that accept 1/4" bits. This compact kit provides standard-length bits suitable for common assembly, repair and installation tasks where a straight reach and compatibility with 1/4" chucks is required.

Advantages

The set offers consistent bit length and hex shank size for reliable fit in 1/4" bit holders and quick-change chucks. Uniform geometry across the eight pieces simplifies tool selection and reduces time spent swapping different sizes. The 60 mm length balances reach and control for many routine fastening operations, and the hardened tips maintain engagement with screw heads to reduce cam-out.

Suitable for

• General household assembly and furniture installation
• Light workshop and maintenance tasks
• Use with powered screwdrivers, cordless drills with 1/4" bit adapters and manual bit drivers
• Repair tasks that require standard-length bits for moderate reach

Key specifications

• Drive type: 1/4" (6.35 mm) hex shank
• Bit length: 60 mm
• Number of pieces: 8 identical bits
• Compatibility: designed for 1/4" quick-change chucks, bit holders and hand drivers
• Material and tip treatment: hardened tips for improved wear resistance

How to use

Select a bit and insert the 1/4" hex shank into the driver or quick-change holder until it locks. Ensure the bit is seated firmly before applying torque. Use appropriate torque settings on powered tools to avoid damaging screw heads; for manual use, apply steady pressure and maintain alignment between the bit and screw. Replace bits that show excessive wear, rounding or chipping to preserve fastening performance.

Usage recommendations

For best results, match the bit type and size to the screw head, avoid excessive side loads, and store the bits in a dry place to prevent corrosion. When using cordless drivers, start at a low torque setting and increase as needed to prevent overdriving.