Flue pipe WADEX D160, 2 mm wall thickness, 0.5 m, black

Flue pipe WADEX D160 is a 0.5 m section with a 160 mm nominal diameter and a 2 mm wall thickness, finished in black. Designed for use as a stovepipe or chimney liner component, this flue pipe is intended to carry combustion gases from heaters, stoves and boilers in residential and light-commercial installations. The straight section provides a standardized connection point for extending flue runs, replacing damaged segments or adapting system layouts while maintaining the internal diameter required by many small to medium heating appliances.

Advantages

The WADEX D160 flue pipe features a robust 2 mm steel wall that resists deformation and accommodates repeated assembly and disassembly. Its black finish offers basic corrosion resistance and a discreet appearance in visible installations. The 0.5 m length allows flexible installation planning, reducing the need for multiple short connectors and helping to achieve required flue heights with fewer joints. Manufactured to match common nominal diameters, the section is compatible with standard D160 fittings and pipe pieces.

Suitable for

• Connecting wood stoves, pellet stoves and small boilers to a flue system
• Extending existing flue runs to achieve proper draft height
• Replacing damaged or corroded straight sections in residential flues
• Temporary or permanent installations in light-commercial heating setups

Key specifications

• Nominal internal diameter: 160 mm
• Wall thickness: 2 mm (steel)
• Length: 0.5 m
• Finish: black coated
• Type: straight flue/ stovepipe section

How to use

Measure the existing flue components and ensure the WADEX D160 section matches the nominal diameter of adjacent pipes and fittings. Slide the section into position using the male/female ends or connector sleeves provided by the system, and secure joints according to the flue system manufacturer’s instructions or local building codes. Seal or fasten connections where required with appropriate high-temperature sealant, clamps or rivets, and maintain recommended clearances to combustibles during installation. Check alignment and support the pipe to prevent sagging or undue stress on joints.

Usage recommendations

Use this WADEX D160 section only in venting systems designed for solid fuel or compatible appliances; verify appliance manufacturer and local code requirements for flue diameter, clearances and material. Regularly inspect joints and the internal surface for soot buildup or corrosion and perform maintenance or cleaning as specified for the heating appliance and chimney system.