Chimney Elbow WADEX 45/90° D200 flue pipe fitting, ø200 mm

Chimney elbow WADEX 45/90° D200 flue pipe fitting, ø200 mm is a metal duct component designed to change the direction of exhaust flows in chimney and venting systems. Made to fit 200 mm diameter flue pipes, this elbow supports both 45° and 90° directional changes, allowing installation in spaces where straight pipe runs are not possible. It is intended for use with residential and light commercial heating appliances to safely route smoke and combustion gases away from the appliance and through the chimney system.

Advantages

The WADEX D200 elbow offers a compact solution for directional changes in flue systems while maintaining a consistent internal diameter to preserve draft performance. Its design minimizes turbulence and backpressure compared with improvised or bent pipe sections. The component is compatible with standard 200 mm flue pipe systems and enables neat alignment of ducts in confined or angled installations.

Suitable for

• Redirecting flue gas flow in residential chimney systems
• Connecting stove, boiler or furnace flues where a directional change is required
• Installation in confined spaces or around structural obstacles
• Retrofit or repair of existing venting runs with 200 mm diameter ducts

Key specifications

• Compatible pipe diameter: 200 mm internal diameter
• Angle options: provides 45° and 90° directional configurations
• Material type: metal construction suitable for flue applications
• Typical application: chimney and venting systems for smoke and combustion gases

How to use

Measure and mark the required position in the flue run where the directional change is needed. Ensure the adjacent pipe ends are clean and free of debris before fitting the elbow. Slide the elbow onto the pipe ends or insert the pipe into the elbow socket depending on system connection style, and secure the joint according to manufacturer or local installation guidelines (e.g., using clamps, fasteners, or sealing methods specified for the flue system). Verify alignment and slope required for proper draft, then complete any required sealing or support to maintain stable and safe installation.

Usage recommendations

Use the WADEX 200 mm elbow only within systems rated for the same temperature and combustion type. Verify compatibility with the chimney system material and local building codes. Inspect joints for leaks after installation and perform regular maintenance checks to ensure unobstructed flue flow and safe operation.