Counter food wrap dispenser Westmark 52632260 Plastic housing for foil and wrap

The Westmark counter food wrap dispenser is a compact plastic housing designed for use with aluminum foil and plastic wrap. With overall dimensions of 335 mm width, 75 mm depth and 145 mm height, the dispenser provides a stable base for cutting and dispensing household wraps while keeping rolls protected and organized on the worktop.

Advantages

The plastic construction delivers a lightweight yet durable casing that resists moisture and routine kitchen wear. The unit’s compact footprint saves counter space while allowing easy one-handed operation. Integrated edges and a guided roll chamber make loading and advancing foil or cling film straightforward, reducing waste and improving cutting accuracy.

Suitable for

• Dispensing and cutting household aluminum foil
• Dispensing and cutting plastic cling film (food wrap)
• Organizing and storing wrap rolls on kitchen worktops
• Small commercial or office kitchen use where a simple dispenser is needed

Key specifications

• Material: durable plastic housing
• Overall dimensions: 335 mm (width) × 75 mm (depth) × 145 mm (height)
• Designed for standard household rolls of aluminum foil and plastic wrap
• Countertop installation: freestanding unit for worktop placement

How to use

Place the dispenser on a flat worktop surface. Open the housing according to the unit’s access points, insert a roll of aluminum foil or plastic wrap into the guided chamber, and thread the film across the cutting edge. Close the housing, pull out the required length of wrap, and use the integrated cutting edge to separate the piece. Operate with slow, steady pressure to ensure a clean cut and to keep the roll aligned within the chamber.

Usage recommendations

For best results, use standard width household rolls that fit comfortably within the 335 mm width capacity. Keep the dispenser clean and dry; wipe with a damp cloth and mild detergent if necessary. Avoid placing heavy objects on top of the unit and do not expose it to direct heat sources. If the cutter becomes blunt, replace the entire unit or the cutting component according to the manufacturer’s guidance.