Twist drill bit 10 mm by Wolfcraft, model 2733000, right-hand rotation, 1 pc, polybag

Wolfcraft 10 mm twist drill bit model 2733000 is a single right-hand rotation bit supplied in a polybag with a hanging hole. Designed for general-purpose drilling in wood-based materials, this 10 mm dowel drill bit creates accurate pilot holes for dowel pin joints and fits standard drill chucks for both handheld and machine use. The bit features a precision-ground cutting edge and a centred point that reduces slipping on start, and it is intended as a replacement or occasional-use accessory for woodworking and assembly tasks.

Advantages

The integrated zinc die-cast depth stop allows controlled drilling to a preset depth and can be quickly mounted using its clamping mechanism, enabling consistent dowel positioning. Precision-ground geometry and central point ensure clean, accurate holes with reduced tear-out. Supplied individually in a polybag with a hanging hole, the single-piece pack is practical for storage and quick replacement.

Suitable for

• Drilling pilot holes for dowel pin joints in wood, plywood, chipboard and fibreboard
• Handheld drilling and drill-press applications with standard chucks
• Assembly and furniture repair tasks requiring precise, repeatable hole depth

Key specifications

• Drill diameter: 10 mm
• Rotation: right-hand
• Material compatibility: wood, plywood, chipboard, fibreboard
• Depth control: integrated zinc die-cast depth stop with clamping mechanism
• Cutting geometry: precision-ground cutting edge with centre point
• Packaging: single piece in polybag with hanging hole

How to use

Install the twist drill bit into the drill chuck and tighten securely. Set the depth stop on the bit to the required drilling depth and fasten the clamp. Position the drill at the marked point, align the centre point with the mark and start drilling at low speed to prevent slipping, then increase speed as required. Use steady pressure and withdraw periodically to clear chips on deeper holes. After drilling, remove the depth stop if not needed for subsequent operations.

Usage recommendations

Use appropriate drill speeds for the material to avoid overheating and ensure clean holes; lower speeds for hard or laminated boards and higher speeds for softwoods. Wear eye protection and secure the workpiece before drilling. For repeatable dowel joints, test depth on a scrap piece and verify fit with the dowel pin set or dowelling jig compatible with the bit.