Hole saw for conduit openings Wolfcraft 1 (model 3473000) for drilling circular cable/pipe entry holes

The Wolfcraft hole saw for conduit openings (model 3473000) is a circular cutting accessory designed for drilling cable and pipe entry holes. It fits standard drill chucks and is intended for creating clean round openings in a range of common building materials when installing conduits, cable grommets or routing pipes through walls, panels and enclosures. The tool is supplied as a single conduit hole saw in storage packaging.

Advantages

This hole saw is suitable for general installation work including sockets, distribution boxes and tubes. It is appropriate for use in brick walls, breeze blocks, plasterboard and tiles. The cutting edge is tungsten carbide coated to increase wear resistance and cutting performance. The product is delivered in a storage box on card for convenient handling and storage.

Suitable for

• Creating circular cable or pipe entry holes in walls and panels
• Installing conduits and cable grommets in buildings
• Routing pipes through brick, block, plasterboard and tiled surfaces
• General electrician and installer tasks requiring round openings

Key specifications

• Type: hole saw for conduit openings
• Compatibility: fits standard drill chucks
• Cutting material: tungsten carbide coated cutting edge
• Suitable materials: brick, breeze block, plasterboard, tiles and similar common building materials
• Contents: 1 conduit hole saw with storage packaging
• Brand: Wolfcraft

How to use

Secure the hole saw in a suitable drill chuck and check that the drill and bit are appropriate for the target material. Mark the center of the intended opening, position the pilot point if present, and start drilling at low speed to establish the cut. Increase speed and apply steady pressure while maintaining alignment. For masonry or tiled surfaces, use appropriate drilling techniques and dust control; when cutting through brittle materials take care to avoid chipping. After cutting, clean the hole edges and remove debris before fitting conduits or grommets.

Usage recommendations

Use personal protective equipment such as safety glasses, dust mask and gloves. For hard masonry or tile work, employ a hammer drill or appropriate drill motor and consider using coolant or intermittent operation to prolong the life of the tungsten carbide coating. Inspect the hole saw for wear before use and replace if cutting performance declines.