Cordless screwdriver accessory Wolfcraft single hole saw Ø83 mm, shank Ø10 mm for tile, granite, glazed tile

Wolfcraft cordless screwdriver accessory single hole saw Ø83 mm with a Ø10 mm shank is designed for use with cordless screwdrivers to create precise holes in hard tile surfaces. The hole saw is suitable for cutting fine stoneware, glazed tile, granite and ceramic tile and is supplied as a single-piece package. A centring drill is integrated, so no additional drilling aid is required, and the sawing edge is coated with industrial diamonds to cut through very hard materials.

Advantages

The diamond-coated cutting edge ensures reliable performance on hard and glazed tiles while the solid-turned main body provides long-term dimensional stability and precision during repeated use. An integrated centring drill simplifies positioning and starts drilling without the need for extra guides. The included sponge allows controlled cooling with water to extend tool life and reduce dust formation. Supplied in a compact storage box and suitable for cordless screwdriver application, the accessory is convenient to transport and store.

Suitable for

• Creating holes for plumbing fixtures and sanitary connections
• Drilling openings for electrical sockets and conduit entries
• Cutting holes for radiator or heater lines and floor outlets
• Installing water connections through tile, granite or glazed surfaces

Key specifications

• Hole saw diameter: 83 mm
• Shank diameter: 10 mm (for cordless screwdrivers)
• Material suitability: fine stoneware, glazed tile, ceramic tile, granite
• Cutting edge: industrial diamond coating
• Design feature: integrated centring drill for guide-free start
• Main body: turned from solid material for precision
• Cooling aid: included sponge for wet cooling to reduce dust and wear
• Packaging: single-piece sticker pack in a storage box

How to use

Mark the desired hole centre on the tiled surface and secure the workpiece if possible. Fit the Ø10 mm shank into the cordless screwdriver chuck and tighten according to the tool manufacturer's instructions. Begin drilling at low speed to allow the centring drill to locate the position, then increase speed and apply steady, moderate pressure. Use the supplied sponge and apply water to the cutting area to cool the diamond edge and minimize dust; pause occasionally to inspect progress and clear debris. After cutting, clean the hole edges and remove any residual slurry before fitting the fixture.

Usage recommendations

Use with a cordless screwdriver that accepts a 10 mm shank and provides controlled speed. For best results on very hard materials such as granite and fully vitrified tiles, keep the cutting zone continuously wetted, avoid excessive feed pressure, and allow the tool to cool periodically to preserve diamond coating life and maintain hole accuracy.